Abstract:Ultrahigh field systems ( ≥ 7 T) can increase the signal-to-noise ratio of magnetic resonance imaging (MRI), improving imaging performance compared to systems with lower fields. However, these enhancements heavily rely on a high B0 magnetic field homogeneity level, which can be achieved through superconducting shimming. This paper presents a novel two-stage superconducting shimming method designed to achieve precise shimming for a 7 T MRI superconducting magnet. In the initial stage, detailed measurements and fittings were conducted to determine the current polarity and the axial or circumferential positions of the shim fields. Subsequently, an optimization strategy was implemented to determine the optimal shim currents with a flexible target field. The second stage involves an iterative process to fine-tune the current of a specific shim coil, identified as having the most significant impact on field homogeneity. The overall fitness of 99.5% underscores the precision in determining the current polarity and position of the shim fields. Significantly, the calibrated shim system substantially improves the peak-to-peak and Root Mean Square Error (RMSE) field homogeneities from 107.42 ppm and 37.00 ppm to 11.12 ppm and 3.26 ppm, respectively, representing improvements of 89.65% and 91.19%. Furthermore, the simulation results of the fine-tuning stage demonstrate additional enhancements in peak-to-peak field homogeneity, to 9.9 ppm by reducing the current of the Z2 shim coil by 51.3 mA. Additionally, the shimmed magnetic field exhibited high time stability, with a maximum variation of only 27 μT observed within 48 h. Thus, the proposed two-stage superconducting shimming framework effectively addresses the challenge of imperfect B0 magnetic fields, enhancing peak-to-peak and RMSE field homogeneity. The stepwise optimized approach also mitigates deviations caused by shim-to-shim coupling, demonstrating its efficacy in achieving precise shimming in ultrahigh-field MRI systems.

Localized Shims Enable Low-Field Simultaneous Multinuclear NMR Spectroscopy

A Broadband NMR Magnetometer System with Field Searching and Automatic Tuning Function

Low Field NMR System Based on High T_c DC-SQUID

RF Shimming Pulses For Ex-Situ NMR Spectroscopy and Imaging Using B1 Inhomogeneities

Implementing a two-stage, shim field-calibrated superconducting shimming method on a 7 T cryogen-free small animal MRI magnet

Phase-Incremented Steady-State Free Precession As an Alternate Route to High-Resolution NMR.

Active shimming for a 25 T NMR superconducting magnet by spectrum convergence method

High-sensitivity multichannel zero-to-ultralow field NMR with atomic magnetometer arrays

Implementing a Two-Stage, Shim Field-Calibrated Superconducting Shimming Method on a 7t Cryogen-Free Small Animal MRI Magnet

High-Field Microscale NMR Spectroscopy with NV Centers in Dipolarly-Coupled Samples

Accelerated Detection for Low-Field NMR Using Nonuniform Sampling and Improved Reconstruction

Multinuclear nanoliter one-dimensional and two-dimensional NMR spectroscopy with a single non-resonant microcoil

Scalable NMR Spectroscopy with Semiconductor Chips.

Super-resolution NMR spectroscopy

Triple oscillating field technique for accurate measurements of couplings in homonuclear spin systems

Enhancing Whole-Brain Magnetic Field Homogeneity for 3D-Magnetic Resonance Spectroscopic Imaging with a Novel Unified Coil: A Preliminary Study

Next‐generation Multidimensional NMR Spectrometer Based on Semiconductor Technology

Geometry-Based Shim Coil Design Applied on an Ultralow-Field MRI System

Magnetic field measurement by NMR imaging

RF shimming strategy for an open 60-channel RF transmit 7T head coil for routine use on the single transmit mode

A Multidisciplinary Approach to High Throughput Nuclear Magnetic Resonance Spectroscopy