Abstract:The power module is one of the main heating sources with non-uniform heat flux in high-power electrical servo systems used for flight vehicles. Faults in the power module are usually caused by a high or a non-uniform temperature. Given the environment of heat dissipation during flight, a regenerative cooling method is typically used, and the cooling system is designed as a microchannel heat sink with supercritical fuel. This is an effective means of solving thermal problems in the flight vehicles. However, because of the high heating power and non-uniform heat distribution of the power module, it is necessary to optimize its heat sink to restrict the high temperature rise and suppress the non-uniform distribution of temperature. In light of these considerations, a 3D numerical model of the microchannel heat sink of a power module with non-uniform heat flux was established in this study to examine the heat transfer and the thermal performance of the cooling channels. Based on the validation of the mesh and numerical method, the simulations of the flow distributions of the channels were performed to assess the thermal performance of the heat sink. It included investigating the effects of the inlet location of the manifold and its injection angle on the flow distribution in the channels, and the influences of the flow distribution and the operational parameters on the thermal performance of the heat sink. The results revealed that the Z30 configuration provided the best location and injection angle of the inlet to match the non-uniform heat flux of the power module. In this case, the values of Stanton number and buoyancy parameter of channel 4 yielded the minimum values of all channels owing to its higher flow rate and gradual rise in temperature. The deviation in the rate of mass flow Φ changed slightly corresponding to the various operational parameters, only the total heat flux would bring a bigger fluctuation. The tiny difference in temperatures among the observation areas on the substrate verified the positive influence of the flow distribution in matching the non-uniform heat flux.

A Novel Microchannel Heat Sink with Staggered Inlet and Outlet to Improve Base Surface Temperature Uniformity

Numerical Study on Performances of Mini-Channel Heat Sinks with Non-Uniform Inlets

An Experimental Study of Microchannel and Micro-Pin-Fin Based On-Chip Cooling Systems with Silicon-to-Silicon Direct Bonding.

Two-phase Flow Oscillation and Distribution in Parallel Channels During R1233zd(E) Subcooled Flow Boiling: A Numerical Study

Experimental and Numerical Study on Thermofluidic Characteristics of Microchannel Heat Sinks with Various Micro Pin–fin Arrays Arrangement Patterns

Numerical Study on Temperature Uniformity in a Novel Mini-Channel Heat Sink with Different Flow Field Configurations

Numerical analysis on thermal-hydraulic performance of optimized microchannel heat sink with slant ribs and quatrefoil rib-elliptical groove complex structures

Numerical study on hydrothermal performance in a microchannel with gradient array of ribs and pin fins

Study on the uneven flow distribution and non-uniform heat transfer in microchannels

Numerical study of different micro-channel structures on fluid flow and heat transfer performance

Effect of Rib Shapes on Flow Boiling Heat Transfer with Staggered Rib Arrays in a Heat Sink

High performance heat sink with counter flow diverging microchannels

Improvement of uniformity in temperature distribution of a microchannel heat sink with secondary inlet

Experimental study of embedded manifold staggered pin-fin microchannel heat sink

Numerical Investigation of Microchannel Heat Sinks with Different Inlets and Outlets Based on Topology Optimization

Experimental and numerical investigation on the heat transfer enhancement for Mini-channel heat sinks with tessellated fins

Temperature uniformity analysis and multi-objective optimization of the microchannel heat sink with cavities under longitudinal vortex flow

Effect of fin shapes on flow boiling heat transfer with staggered fin arrays in a heat sink

Numerical Analysis of Flow Boiling Characteristics of a Single Channel Heat Sink Subjected to Multiple Heat Sources

Local hydrothermal characteristics and temperature uniformity improvement of microchannel heat sink with non-uniformly distributed grooves

Heat Transfer Enhancement and Temperature Uniformity Improvement of Microchannel Heat Sinks with Twisted Blade-Like Fins