Abstract:This work deals with the lunar sample return project, which requires lunar samples to be returned back to the ground without contamination. In this paper, a knife edge indium seal is proposed as a primary sealing form, where indium–silver alloy is welded into an annular groove of a cylindrical container firstly and then extruded by an annular knife edge of a cylindrical lid. The analysis of the leakage and sealing reliability of knife edge indium seal is the main aim of this paper. Firstly, the pretreatment of knife edge indium seal is discussed. Key techniques on indium welding are studied to evaluate its sealing reliability, with the tensile strength and welding void ratio mainly being discussed. Secondly, by means of “Roth” leakage theory, mathematical models on the leak rate for knife edge seal are established. By means of the finite element analysis, the knife edge geometry is optimized with minimum pressing force required. The results justify that the knife edge seal demands much lower pressing force to achieve a considerable sealing performance, which is suitable for low-powered operation. Finally, the ground tests are carried out to evaluate the feasibility of the indium welding and to measure the leak rate of the knife edge indium seal. Experimental results demonstrate the indium welding onto the stainless steel container is feasible, and the leak rate at room temperature is 3.0 × 10−10 Pa·m3/s, which is much lower than the rubber O-type ring seal. The knife edge indium seal is suitable for lunar sample return devices.

Design and Experimental Validation of Sealing Assembly for Lunar Regolith Volatile Extraction Heating Furnace

Research on Sealing Structure and Ground Test of Lunar Sample Return Devices

Micro Quantitative Sampler for Lunar Regolith: Design and Validation

Leakage Analysis and Ground Tests of Knife Edge Indium Seal to Lunar Sample Return Devices

Quantitative Sampling and Thermal Extraction of the Lunar Regolith for Lunar Volatile Exploration: Method and Validation

A review of encapsulation techniques for planetary samples

A Novel Sample Manipulation Device (SMD) for Lunar Regolith Volatile In-Situ Exploration: Method and Validation

Sealing Performance Analysis of Deep-Sea Sediment Sampler

Design and Experimental Verification of a Novel Sampling System for Water Ice in the Lunar Soil

Design and Verification of a Novel Sampling System for Lunar Water Ice Exploration

A Spiral Seal Method in the Lunar Regolith for Chang'E-5 Drill: Seal Design and Experiment

Fabric Simulation and Mechanical Characteristics Test and Analysis of Icy Lunar Regolith

Measurement and Uncertainty Analysis of Lunar Soil Water Content Via Heating Flux Method

A Sample Repetitive Manipulation Mechanism (SRMM) for Lunar Regolith In-Situ Analysis: Design and Validation.

Modeling and Analysis for Volatile Characteristics of Lunar Water Ice

Study of Drilling-Based Water Extraction Technology from Icy Lunar Regolith

Leakage analysis and ground tests of the O-type rubber ring seal applied in lunar sample return devices

Design of an Automatic Sealing Mechanism for Extraterrestrial Sample-Collecting Robot

Micro Quantitative Sampling Using Electric Adsorption for Lunar In-Situ Volatiles Exploration: Method and Validation

A novel auger-based system for extraterrestrial in-situ water resource extraction

A Pre-Treating Device For Drilling Sample In Lunar Exploration