Abstract:Compared with the position sensor control, sensorless control avoids a lot of defects caused by the position sensor, at the same time makes the system more stability and stronger anti-interference performance, it has more advantages and meets control field's requirements better in the future, it has gradually become a hotspot in the brushless DC motor control field. The rotor position detection has been a very critical research in the brushless DC motor sensorless control. In this paper, a new type of rotor position detection method is proposed, which is based on the principle and mathematical model of a brushless DC motor after the analysis of advantages and disadvantages of the back EMF principle of zero-detection and the method of the back-EMF superposition, which means a combination of the method of the two rotor position detection, as above. This method neither need a delay of 30° nor require a depth filter, the hardware circuit is also simple and there is no need to compensate for the phase shift. Then, the frequency of the detection signal is three times of fundamental wave frequency in this method and the detection signal is easier to detect when the motor running at low speed, which expand the applicable speed range of the electric motor. This paper analyzes the principle and commutation logic of the rotor position detection method, it come up with a conclusion that the stagnation point of the three BEMF superposition derivative is the commutation points of the stator windings, and it uses the method of the back-EMF zero crossings to determine the current conduction state. The simulation model of the brushless DC motor's control system is established in MATLAB /Simulink it uses speed and current double close loop PI control. The result shows that the method is correct and feasible, it can get the right rotor position signal and control motor commutation correctly, the method can achieve the control of brushless DC motor without position sensor, and it can provide a reference for further research.

Deflection Position Detection of Permanent Magnet Spherical Motor Based on the Back-EMFs Differences of the Tilting Stator

Analysis and Suppression of Rotor Eccentricity Effects on Fundamental Model Based Sensorless Control of Permanent Magnet Synchronous Machine

Checking method of initial position for surface-mounted permanent magnet linear synchronous motor

Rotor Position Identification of Permanent Magnet Spherical Motor Based on Equilateral Spherical Triangles

Radial Position Detection Of Five-Phase Bearingless Pm Motor

An Improved Method to Estimate Initial Rotor Position for Surface-Mounted Permanent Magnet Synchronous Motors

An Improved Rotor Position Estimation Method for PMSM Using Low-Resolution Hall-Effect Sensors

An EMF Observer for PMSM Sensorless Drives Adaptive to Stator Resistance and Rotor Flux Linkage

Back Electromotive Force-Based Discrete-Time Rotor Position Bias Compensation Method for Permanent Magnet Synchronous Motors

Sensorless Posture Detection of Reluctance Spherical Motor Based on Mutual Inductance Voltage

A Novel Initial Rotor Position Estimation Method for Permanent Magnet Synchronous Motors

Analytical torque model for a permanent magnet spherical motor using magnetic field reconstruction from measured boundary conditions

Attitude estimation of a permanent magnet spherical motor based on an improved fast discriminative scale space tracking algorithm

Planar Position for Permanent-Magnet Synchronous Motor Using Historical and Magnetic-Detection Information

Initial Rotor Position Detection for Permanent Magnet Synchronous Motor Based on High-Frequency Voltage Injection without Filter

An improved rotor position estimation in PMSM with low-resolution hall-effect sensors

Rotor Position Estimation Strategy for Self-Sensing Active Magnetic Bearing Considering Eddy Currents

Detection of Rotor Position with MR Sensor TLE5309D

A Novel Rotor Position Detection Method for Sensorless Control of Magnetic-Geared Permanent-Magnet Brushless Motor

Demagnetization Fault Detection and Location in PMSM Based on Correlation Coefficient of Branch Current Signals

Rotor position detection based on BEMF zero-crossing detection method with three-EMF force superposition