Abstract:Multi-voltage threshold (MVT) digitization, which has been implemented in our preclinical scanner-Trans-PET BioCaliBurn, is a low-power sampling solution with a reasonable cost for fast scintillation pulses. This MVT digitizing scheme employs a few comparators with programmable reference voltages for determining the time points when the scintillation pulse crosses the user-defined voltage thresholds. After obtaining the digital time samples, use of various sophisticated linear or nonlinear algorithms to improve the accuracy of timing information becomes possible. In the previous implementation of MVT digitizers, the arrival time of a scintillation pulse was determined by the linear fitting (LF) algorithm, which assumes leading edge as a straight line, and not involves the transition time on the falling edge. It is not unreasonable to expect achieving a better timing resolution in MVT-based PET detectors by the combinatorial optimization of MVT samples both on leading and falling edges. In this paper, a novel method, referred to as quadratic programming (QP) method is therefore proposed to mark the time stamps of sampling event pulses. In this method, the arrival time is directly expressed as a parametric combination of the MVT samples. The parameters in the combination are obtained by the quadratic programming which minimizes variation of timing error. To evaluate the performance of QP/MVT method and other time pickoff methods, we setup two gamma ray detectors using LaBr3:Ce crystal and Hamamatsu R9800 PMT. The scintillation pulses are directly read out by Tektronics DPO 71604 digital storage oscilloscope. CTR of 175 ps was obtained by QP/MVT, and 191 ps by LF/MVT, when four thresholds were employed in each of the two channels. The experimental results indicate the potential advantage of QP/MVT in timing determination. Meanwhile, the assumption of linear leading edge, which is the basis of LF method, was demonstrated to be improper in the data analysis. For QP method, probably of even greater significance is the manner to define the parameters rather than the resulting detector-specified parameters.

Performance Evaluation of Eight-Channels Picosecond Chip MVT22_8LF

FPGA-Only MVT Digitizer for TOF PET

A 72-Channel Fpga-Only Mvt Digitizer Board And A Micro-System For Coincidence Detection/Imaging

A digital PET system based on SiPMs and FPGA-only MVT digitizers

Design and Implementation of a Peak Picking System for MVT Digitizer

Timing Optimization For Digital Pet Detector Module Based On Fpga-Only Mvt Digitizers

A PET detector module using FPGA-only MVT digitizers

A Photon-Counting X-ray Detector Using SiPM and FPGA-only MVT Digitizer

Performances Study on TDC Timing Samples Resolution in a MVT Chip

Quadratic Programming Time Pickoff Method for Multi-Voltage Threshold Digitizer in PET

A Novel Peak Picking Multi-Voltage Threshold Digitizer for Pulse Sampling

Multi-voltage threshold digitizer using a time-varied threshold for photon-counting X-ray security inspection imaging

Tof Pet Detectors Employing Stripline Based Readout and Mvt Digitizer

Design and Characteristics of a Multichannel Front-End ASIC Using Current-Mode CSA for Small-Animal PET Imaging.

A CMOS Time-to-digital Converter for Multi-Voltage Threshold Method in Positron Emission Tomography

Development of an Eight-Channel Time-Based Readout Asic for Pet Applications

Evaluation of a PET detector based on SiPMs and FPGA-only MVT digitizers

Development of a Multi-Channel ASIC with Individual Energy and Timing Digitization for SiPM Detectors for TOF-PET Applications

Real Time Processing Module for Scintillation Pulse Timing Information

Characteristics of a Multichannel Low-Noise Front-End ASIC for CZT-based Small Animal PET Imaging

An Analog Front-end ASIC Design for 16-Channel SiPM Readout in PET Detectors