Abstract:In Section 2.3, paragraph 2, the first sentence should read: “Comparing the results (Figure 5), the membranes all has a qmax value of near 2.25 nm−1.” The qmax value is 2.25 nm−1 rather than 3.25 nm−1. SAXS profiles of PVDF/PEO/DBS-H membranes at room temperature. In the Experimental Section, paragraph 3, the fifth sentence should read: “The scattering patterns were integrated to generate an I vs q curve, where I is the intensity of scattered X-rays and q is the scattering vector r, q is calculated from scattering angle θ and the wavelength of the X-ray beam λ by the equation q= 4πsin (θ)/λ.” The remaining two sentences of that paragraph should be disregarded. Figure 5 in the original manuscript should be replaced by the new version of Figure 5 shown below. Figure 5 in the published article is the relation between scattering intensity and the scattering angle, rather than q [calculated as q=4πsin (θ)/λ], due to an oversight by the author. The caption remains the same and is included for completeness. The author apologises for these oversights.

Progress of Surface Science Studies on ABX3‐Based Metal Halide Perovskite Solar Cells

Correction: Chen et al., Orbital Angular Momentum Generation and Detection by Geometric-Phase Based Metasurfaces. Appl. Sci. 2018, 8, 362

Corrections to “zinc Oxide Nanostructures and High Electron Mobility Nanocomposite Thin Film Transistors” [nov 08 3001-3011

Correction to "Enhanced Photostability of Lead Halide Perovskite Nanocrystals with Mn 3+ Incorporation"

Correction to "Multicomponent Approach for Stable Methylammonium-Free Tin-Lead Perovskite Solar Cells"

Correction: Interfacial engineering between SnO2/MAPbI3 by maleate pheniramine halides toward carbon counter electrode-based perovskite solar cells with 16.21% efficiency

Erratum: Intrinsic and Extrinsic Charge Transport in CH3NH3PbI3 Perovskites Predicted from First-Principles

Erratum: A Stable Quasi-Solid-state Dye-Sensitized Solar Cell with an Amphiphilic Ruthenium Sensitizer and Polymer Gel Electrolyte

Correction to: Bismuth Yttrium Oxide (Bi3YO6), A New Electrode Material For Asymmetric Aqueous Supercapacitors

Berichtigung: Solvatochromic Photoluminescent Effects in All‐Inorganic Manganese(II)‐Based Perovskites by Highly Selective Solvent‐Induced Crystal‐to‐Crystal Phase Transformations

Corrigendum: New Anhydrous Proton Exchange Membrane for Intermediate Temperature Proton Exchange Membrane Fuel Cells

Correction to "Zwitterions in 3D Perovskites: Organosulfide-Halide Perovskites"

Correction: BaTiO3–BiYbO3 Perovskite Materials for Energy Storage Applications

Correction: Understanding the ultraviolet, green, red, near infrared and infrared emission properties of bismuth halide double perovskite

Intramolecular Copper‐Containing Hyperbranched Polytriazole Assemblies for Label‐free Cellular Bioimaging and Redox‐Triggered Copper Complex Delivery

Correction: A Hole-Transport Material That Also Passivates Perovskite Surface Defects for Solar Cells with Improved Efficiency and Stability

Correction: Control of aggregation and dissolution of small molecule hole transport layers via a doping strategy for highly efficient perovskite solar cells

Correction: Steering the Crystallization of Perovskites for High-Performance Solar Cells in Ambient Air

Correction: Structural, electronic, optical, elastic, thermodynamic and thermal transport properties of Cs 2 AgInCl 6 and Cs 2 AgSbCl 6 double perovskite semiconductors using a first-principles study

Correction: Temporal and Spatial Pinhole Constraints in Small-Molecule Hole Transport Layers for Stable and Efficient Perovskite Photovoltaics

Correction: Recent progress on covalent organic frameworks for photocatalytic hydrogen generation via water splitting