Abstract:Piezoelectric devices based on high-temperature stable single crystals are of increasing interest due to a wide range of potential applications, such as actuators and resonant gravimetric sensors. The latter require highly accurate resonant-frequency measurements at temperatures as high as 1000 °C, and this can only be achieved with narrow resonance peaks and correspondingly low acoustic loss at these temperatures. Relevant atomistic defects in langasite (La 3 Ga 5 SiO 14 , LGS) and catangasite (Ca 3 TaGa 3 Si 2 O 14 , CTGS) are reviewed with respect to their impact on electrical conductivity and acoustic loss. The focus on these crystals also enables a comparison of electroacoustic properties of partially disordered (LGS) and ordered (CTGS) crystals and the formulation of approaches for reducing acoustic loss and enhancing device performance. Starting with defect chemistry models for LGS and CTGS, electrical conductivities as a function of temperature and oxygen partial pressure are considered. One result of this analysis is that contributions of oxygen ions to the total conductivity are determined to be relatively small in the studied crystals. Temperature-dependent acoustic loss of LGS and CTGS crystals is also studied. Two independent techniques, contact resonant piezoelectric spectroscopy, and a contactless tone-burst excitation technique, are applied. Contributions to the measured acoustic loss are determined by fitting loss-related functions for point defects and conductivity-related relaxations. The extracted fit parameters, in particular the activation energies of the processes, are discussed and compared with that of the electrical conductivity. The losses are caused by a superposition of several mechanisms including conductivity-related relaxations, point-defect relaxations and intrinsic phonon-phonon loss. The long-term stability of the crystals is also evaluated at 1000 °C with respect to fundamental materials properties including electrical conductivity and resonant frequency. After one year of thermal treatment, the resonance frequency of CTGS resonators from different crystal sources is found to decrease by no more than 0.4 %. Thus, the applicability of CTGS as a piezoelectric resonator that operates for long periods at extreme temperatures, such as a resonant nanobalance, is demonstrated. Application examples to be presented include resonant nanobalances for in-situ monitoring of non-stoichiometry and phase transformations in thin films during growth at high temperatures. In this context, the key application properties of the sensors at high temperatures, such as mass sensitivity and resolution, are discussed. As an application example, the attached figure shows the oxygen non-stoichiometry x of thin praseodymium-cerium oxide films (Pr 0.1 Ce 0.9 O 2-x ) at 700 °C as a function of oxygen partial pressure determined by LGS and CTGS nanobalances, which agrees very well with literature data (chemical capacitance: D. Chen et al., Chem. Mater. 2014, 26, 22, 6622–6627). Figure 1

Characterization of High Temperature Resistivity and Full Matrix Material Coefficient of LGT Crystals

Single-crystal Y_2O_3-ZrO_2 Rectangular Waveguides for Ultrahigh-Temperature Sensing Applications

High-Quality Rectangular Y2o3-Zro2 Single Crystal Optical Waveguides For High-Temperature Fiber-Optic Sensors

Growth of large langatate (La3Ta0.5Ga5.5O14, LTG) crystals with high electrical resistivity

High-Temperature Piezoelectric Resonators: Electroacoustic Properties and Applications of Langasite-Type Crystals

Characterization of high temperature piezoelectric crystals with an ordered langasite structure

Langasite as Piezoelectric Substrate for Sensors in Harsh Environments: Investigation of Surface Degradation under High-Temperature Air Atmosphere

Novel Multilayer SAW Temperature Sensor for Ultra-High Temperature Environments

Surface Effects and Challenges for Application of Piezoelectric Langasite Substrates in Surface Acoustic Wave Devices Caused by High Temperature Annealing under High Vacuum

Ultra high temperature saw sensors based on signle crystalline a1n and multilayer composite electrode

Tungsten as a Chemically-Stable Electrode Material on Ga-Containing Piezoelectric Substrates Langasite and Catangasite for High-Temperature SAW Devices

High thermal stability of ultra-high temperature surface acoustic wave devices with multilayer composite electrodes

Design and Directional Growth of (Mg 1− x Zn x )(Al 1− y Cr y ) 2 O 4 Single‐Crystal Fibers for High‐Sensitivity and High‐Temperature Sensing Based on Lattice Doping Engineering and Acoustic Anisotropy

Surface Acoustic Wave Sensors for Wireless Temperature Measurements above 1200 Degree Celsius

High-temperature shear-type vibration sensor based on langasite piezoelectric crystal

Novel Surface Acoustic Wave Strain Sensor with Enhanced High-Temperature Performance and Resistance to Aging

A piezoelectric vibration sensor with excellent performance based on Bi12SiO20 crystal for high-temperature applications

Characterization of Elastic Constants of Langatate Single Crystals with 32 Symmetry Using Ultrasonic Pulse‐Echo Technique

New Composite Electrode for High Temperature Surface Acoustic Wave Device

Piezoelectric Sensors Operating at Very High Temperatures and in Extreme Environments Made of Flexible Ultrawide‐Bandgap Single‐Crystalline AlN Thin Films