Abstract:In the scenario of high dynamics and low C/N0, the discriminator output of a GNSS tracking loop is noisy and nonlinear. The traditional method uses a fixed-gain loop filter for error estimation, which is prone to lose lock and causes inaccurate navigation and positioning. This paper proposes a cascaded adaptive vector tracking method based on the KF+EKF architecture through the GNSS Software defined receiver in the signal tracking module and the navigation solution module. The linear relationships between the pseudo-range error and the code phase error, the pseudo-range rate error and the carrier frequency error are obtained as the measurement, and the navigation filter estimation is performed. The signal C/N0 ratio and innovation sequence are used to adjust the measurement noise covariance matrix and the process noise covariance matrix, respectively. Then, the estimated error value is used to correct the navigation parameters and fed back to the local code/carrier NCO. The field vehicle test results show that, in the case of sufficient satellite signals, the positioning error of the proposed method has a slight advantage compared with the traditional method. When there is signal occlusion or interference, the traditional method cannot achieve accurate positioning. However, the proposed method can maintain the same accuracy for the positioning results.

Phase-and-rate Feedback Loops for Weak GNSS Signals Tracking

Method of Code Tracking Loop Bandwidth Stabilization Adjustment for Inter-satellite Ranging System

Study on the Tracking Accuracy of Regenerative Ranging Codes Used in Micro-Satellite Transponders

Impact of Data Channel on Tracking Performance of Pseudo-Code Tracking Loop

A New NCO Model for Tracking Loop Design in GNSS Software Receivers

A Frequency-Compensation Algorithm in Kalman Filter-Based Tracking Loop for High-Dynamics GNSS Receivers

Performance and Evaluation of GNSS Receiver Vector Tracking Loop Based on Adaptive Cascade Filter

Algorithm Design and Simulation Test for Software GNSS Receiver

Tracking Method Based on Multi-Carrier-Loops for GPS Signal under High Dynamic Conditions

Dual Update-Rate Fll-Assisted Phase Lock Loop of Novel Robust Receivers for New Generation Global Navigation Satellite Signals

An Algorithm Based on Dynamic Compensation for GNSS Carrier Tracking of Weak Signal

A high-sensitivity GPS receiver carrier-tracking loop design for high-dynamic applications

Dual Update-Rate Carrier Tracking Technique for New Generation Global Navigation Satellite System Signals in Dynamic Environments

Joint Vector Tracking Loop In A Gnss Receiver

Vector Tracking Loops in GNSS Receivers for Dynamic Weak Signals

Carrier Loop's Performance Evaluation and Simulation in High Dynamic GNSS Receiver

Frequency Diversity Combined Robust GNSS Signal Tracking Using a Bank of Correlators

Generalized GNSS Signal Carrier Tracking—Part II: Optimization and Implementation

Remote Phase Synchronization For Satellite Network Systems

The Explicit Tuning Investigation And Validation Of A Full Kalman Filter-Based Tracking Loop In Gnss Receivers

Tracking Loops Design and Bandwidth Optimization for SINS-aided GPS Receiver.