Abstract:Adaptive arrays have been widely used for interference mitigation in Global Navigation Satellite System (GNSS) receivers. Unlike adaptive nulling, adaptive beam-forming generates a dedicated beam in the antenna pattern towards each individual satellite and form nulls in the interference directions at the same time. Thus, the satellite signals are enhanced while interferences are mitigated, resulting in improved signal-to-interference-plus-noise ratio (SINR). In previous literature mainly two categories of beam-forming mechanisms are recommended, namely the array synthesis method and the so-called "blind" beam-forming method. The array synthesis method calculates the steering vector directly, but needs a cumbersome correction procedure dealing with the non-ideal factors of the antenna array and radio frequency (RF) channels. The blind beam-forming method generates the steering vector on-the-fly using carrier phases collected by auxiliary tracking channels, thus avoids the correction procedure, but has a limited performance against interferences. As an alternative, we proposed a different beam-forming method, which can be regarded as a combination of the two above. This method consists of two steps. In the calibration step, a carrier phase look up table (LUT) is obtained using the live-sky signals. In the beam-forming step, the steering vector is generated by looking up the LUT. This method doesn't need a cumbersome non-ideal factor correction procedure, and has a good anti-interference performance, thus can be a third option for beam-forming.In order to implement and validate this method, a software-defined approach is used. Two real-time software receivers, one for the calibration step and one for the beam-forming step are designed and implemented. In order to meet the real-time requirement, a graphics processing unit (GPU) is used as an accelerator. A batched programming technique is used to fully take advantage of the parallelism offered by the GPU. Software design and programming details are introduced. Experiments are conducted in real environment and results are given. It concludes that this method has a good beam-forming performance in improving C/N-0 and getting more precise positioning results.

An Algorithm Based on Dynamic Compensation for GNSS Carrier Tracking of Weak Signal

Carrier Tracking Algorithm Based on Adaptive Unscented Kalman Filter in High Dynamic

A Frequency-Compensation Algorithm in Kalman Filter-Based Tracking Loop for High-Dynamics GNSS Receivers

Frequency Diversity Combined Robust GNSS Signal Tracking Using a Bank of Correlators

FFT Tracking Based High Dynamic GPS/INS Scalar Deeply Integrated Navigation Algorithm

A high-sensitivity GPS receiver carrier-tracking loop design for high-dynamic applications

Vector Tracking Loops in GNSS Receivers for Dynamic Weak Signals

Design of acquisition algorithm based on a novel detector for weak GNSS signals

Performance and Evaluation of GNSS Receiver Vector Tracking Loop Based on Adaptive Cascade Filter

Kalman Filter with Adaptive Covariance Estimation for Carrier Tracking under Weak Signals and Dynamic Conditions

A vector tracking loop based on ML estimation in dynamic weak signal environments

Algorithm Design and Simulation Test for Software GNSS Receiver

Weak Signal Acquisition of GNSS Based on Code Doppler and Local Clock Skew Compensation

Dual Update-Rate Carrier Tracking Technique for New Generation Global Navigation Satellite System Signals in Dynamic Environments

A low complexity fast acquisition algorithm for GNSS signal

Energy Frequency Discriminator for Gnss Carrier Tracking

A Fine Acquisition Algorithm Based on Fast Three-Time FRFT for Dynamic and Weak GNSS Signals

High Dynamic Carrier Tracking Using Kalman Filter Aided Phase-Lock Loop

Low-Complexity Code Tracking Loop with Multipath Diversity for Gnss over Multipath Fading Channels

Preliminary insights on fast GNSS signal capture using SFT and FFT frequency shift

A Two-Step Beam-Forming Method Based on Carrier Phases for Gnss Adaptive Array Anti-Jamming