Abstract:Flash point is one of the most important parameters used to characterize the potential fire and explosion hazards for flammable liquids. In this study, flash points of twenty eight binary miscible mixtures comprised eighteen flammable pure components with different compositions were measured by using the closed cup apparatus. The obtained experimental data are further employed to develop simple and accurate models for predicting the flash points of binary miscible mixtures. Based on the vapor liquid equilibrium theory, the normal boiling point, the standard enthalpy of vaporization, the average number of carbon atoms, and the stoichiometric concentration of the gas phase were selected as the dominant physicochemical parameters that were relevant to the overall flash point property of liquids. With these parameters for pure components as well as the compositions of mixtures, the new form of characteristic physicochemical parameters for mixtures were developed and used as the input parameters for the flash point prediction of mixtures. Both the modeling methods of multiple linear regression (MLR) and multiple nonlinear regression (MNR) were employed to model the possible quantitative relationships between the parameters for mixtures and the flash points of binary miscible mixtures. The resulted models showed satisfactory prediction ability, with the average absolute error for the external test set being 2.506 K for the MLR model and 2.537 K for the MNR model, respectively, both of which were within the range of the experimental error of FP measurements. Model validation was also performed to check the stability and predictivity of the presented models, and the results showed that both models were valid and predictive. The models were further compared to other previously published models. The results indicated the superiority of the presented models and revealed which can be effectively used to predict the FP of binary miscible mixtures, requiring only some common physicochemical parameters for the pure components other than any experimental flash point or flammability limit data as well as the use of the Le Chatelier law. This study can provide a simple, yet accurate way for engineering to predict the flash points of binary miscible mixtures as applied in the assessment of fire and explosion hazards and the development of inherently safer designs for chemical processes. (C) 2015 Elsevier Ltd. All rights reserved.

Quick Calculation and Applications of Adiabatic Flash

GENERAL FLASH CALCULATION BY THE NEWTON- RAPHSON METHOD

On Understanding the Transition from Internal to External Flash Boiling

Numerical analysis of flash-boiling spray characteristics with liquid ammonia

Rear-surface integral method for calculating thermal diffusivity from laser flash experiments

A projection procedure to obtain adiabatic flames from non-adiabatic flames using heat flux method

CFD-Based Numerical Simulation of Water Film Flash Evaporation with a New Flash Evaporation Model

Calculation and Analysis on Evaporation and Mixing Characteristics of Droplets in High Temperature Flue

Experimental and numerical simulation study on the mass transfer characteristics of static flash evaporation

Calculation of combustion air required for burning solid fuels (coal / biomass / solid waste) and analysis of flue gas composition

Thermal calculation method for direct-contact flue-gas-water condensation heat exchangers

Heat and mass transfer characteristics of non-equilibrium flash at start stage

Optimization of adiabatic flame temperature of natural gas combustion under different conditions

Experimentaldetermination and calculation of flash point of binary miscible liquid mixtures

Object-oriented program for calculating thermodynamic properties of flue gas

A Novel Method to Accelerate the Three-phase Flash Calculation of the Hydrocarbon-CO 2 System

Experimental Study on the Flash Evaporation Process of LiBrH2O Solution in an Absorption Heat Pump

On Mechanism And Optimization Of High Temperature/Low Oxygen Combustion

Flash Points Measurements and Prediction for Binary Miscible Mixtures

Numerical Simulation of Catalytic Combustion of CH4 in a Micro-burner

Variable Property Analysis of Flame-Sheet Combustion Within the Blasius Boundary Layer Over an Ablating Surface