Abstract:The dynamic modulus (|Em*|) of asphalt mixtures is one of most fundamental mechanical parameters used in flexible pavement design, which has been extensively estimated through various predictive models. However, most of existing dynamic modulus predictive models does not fit well for the purpose of the Level 3 (the lowest input level) flexible pavement design in the current AASHTOWare Pavement ME Design due to the following major deficiencies: (1) lacking physical significance; (2) providing poor prediction accuracy; and (3) requiring laboratory testing to obtain key model parameters. To address these deficiencies, this paper is aimed to develop a new model on the basis of the law of mixtures. First, a large database is collected and revised for the new model development. Two exiting law of mixture models are then evaluated in terms of the mode prediction accuracy, and neither of them provided satisfactory prediction results. A new model is subsequently developed, which involves using a parallel form to represent the contribution of each of three phases (asphalt, aggregate and air void) to the |Em*| as well as utilizing a standard sigmoid function to characterize the mechanical response of asphalt mixture. Statistical analysis shows that the new model has comparable prediction performance with traditional Witczak models, but with significantly lower number of input variables and relatively higher model quality. Supplemental data collected from laboratory tests and independent literature sources finally validate that the new model has the capability to provide an accurate prediction of |Em*| with an R2 value up to 0.90. In these regards, the new model is believed to be a good candidate for the |Em*| prediction of asphalt mixtures for a reliable Level-3 flexible pavement design.

The Characteristic Analysis of Dynamic Modulus in Pavement

Mechanical Analysis of the Effect of Overloading on Pavement Performance

A Novel Approach for the Mechanical Response of Cement Concrete Pavement Structure Considering the Interlaminar Interface Shear Slip Effect

Structural Mechanics Analysis of Asphalt Pavement Using Large Stone Asphalt Mixture As Base

Elastoplastic Analysis of Asphalt Concrete Pavement

Dynamic analysis of asphalt pavement with reflective cracking on the soft clay ground

Determination of Complex Modulus Gradients of Flexible Pavements Using Falling Weight Deflectometer and Artificial Intelligence

Development of a Modulus of Subgrade Reaction Model to Improve Slab-Base Interface Bond Sensitivity

A New Dynamic Modulus Predictive Model for Asphalt Mixtures Based on the Law of Mixtures

Inverse Engineering Stress-Dependent Resilient Moduli of Cement-Treated Base Materials in Asphalt Pavements Using Falling Weight Deflectometer

Numerical Analysis on Deformation of Pavement and Soft Clay Ground Interaction for Cyclic Loads

Dynamic Response of Reinforced Pavements System Subjected to Moving Loads

Dynamic response analysis of asphalt pavement under three-directional nonuniform moving load

Cracking Analysis of Asphalt Pavement Based on Dynamic Modulus

Dynamic Response of Pavement Subjected to Moving Traffic Load

Investigation of the Relationship between Permanent Deformation and Dynamic Modulus Performance for Bearing-Layer Asphalt Mixture.

Monitoring the Structural Capacity of Airfield Pavement with Built-in Sensors and Modulus Back-Calculation Algorithm

The Relationship between Dynamic and Static Deformation Modulus of Unbound Pavement Materials Used for Their Quality Control Methodology

Dynamic Mechanical Analysis of Asphalt Pavement Based on Cross-isotropic Properties

Consequence Analysis of Smoothness to Cement Concrete Pavement's Fatigue Failure

A Dynamic Identification Approach to Foundational Response Modulus for Airport Pavement