Abstract:The cadmium sulfide (CdS) n-type semiconductor is one of the most used as a window layer in thin-film solar cells, such as CdTe, CIS, CIGS, and CZTS. Optoelectronic properties are the most important characteristics for window materials. CdS thin films obtained using the chemical bath deposition technique (CBD) have been reported; however, large amounts of precursor solutions are used, which generate considerable amounts of toxic waste. The aim of this work is to reduce the amount of precursor solutions used for CdS growth; for this, it is necessary to consider an efficient position for the substrate inside the reactor container and at the same time allow obtaining CdS thin films with adequate physical properties to be applied in the photovoltaic solar cell development. CdS thin films were deposited on soda-lime/SnO2:F substrates (FTO) using the CBD technique; the substrates were placed in three different arrangements [rack system, step system (up), and step system (down)]. CdS samples with areas of 4 cm2 and a thickness of 27-48 nm were obtained; the X-ray diffraction patterns show CdS thin films with different polycrystalline structures. The morphological measurements reveal different surface formations depending on the substrate position, and resistivity values of around 105 Ω*cm were measured. UV-vis spectra show transmittance values of around 45-94% in the visible region with band gap energy values of around 2.1-2.36 eV. The best physical properties of CdS thin films and an efficient CBD process were obtained when the FTO substrates were located near the bottom of the reactor container with the FTO side down, leading to an optimal configuration that allows reducing the amount of precursor solutions and in this way reduces the toxic waste generated. These results are important in the photovoltaic technology process and environmental impact.

Preparation and properties of CdS thin films with large area

CdS THIN FILMS FABRICATED BY CHEMICAL BATH DEPOSITION

Effects of complexing agent on CdS thin films prepared by chemical bath deposition

Influence of growth process on the structural, optical and electrical properties of CBD-CdS films

Synthesis of CdS nanotubes by chemical bath deposition

[Research on the Polycrystalline CdS Thin Films Prepared by Close-Spaced Sublimation].

Preparation and Characterization of CdS by Evaporation and Cu2S Complex Photoelectric Thin Films

Comprehensive Analysis of CdS Ultrathin Films Modified by the Substrate Position inside the Reactor Container Using the CBD Technique

Cds Thin Films Deposited by Cbd Method on Glass

Good Optical Properties of Branched CdS Nanoparticles and Its Large Area Growth via Solvothermal Route

Optical and Electrical Properties of CdS Films

A Study on the Preparation and Structure of Cadmium Sulfide Nanoparticulate Organized Assembly System

Solvothermal Synthesis and Characterization of Uniform CdS Nanowires in High Yield

Optical Transmission, Photoconductivity, and Morphology of Chemical Bath-Deposited CdS Thin Films for Optoelectronic Applications

Effect of Substrate and Zn Doping on the Structural, Optical and Electrical Properties of Cds Thin Films Prepared by Cbd Method

An Optimized Multilayer Structure of CdS Layer for CdTe Solar Cells Application

Preparation and Characterization of Cuins2 Thin Films for Solar Cells by Chemical Bath Deposition

Preparation and characteristics of CdS thin films by dip-coating method using its nanocrystal ink

Directional CdS Nanowires Fabricated by Chemical Bath Deposition

In-situ Growth of a CdS Window Layer by Vacuum Thermal Evaporation for CIGS Thin Film Solar Cell Applications

High-efficiency CdTe-based Thin-Film Solar Cells with Unltrathin CdS:O Window Layer and Processes with Post Annealing