Abstract:High-performance alloy materials are increasingly considered for various engineering applications due to their combination of desirable properties. However, the guided wave-based structural health monitoring of alloys is often challenged by their strong anisotropic nature, which makes it difficult to calculate the guided wave behavior and associate mode shapes. In this article, Lamb mode waves of Cu–Al–Ni alloy under uniaxial stresses are characterized by developing a novel numerical polynomial approach, which may provide an efficient way to solve problems concerning acoustic wave propagations. To facilitate understanding of the dispersion curve trajectories, the anisotropic phase transformation from cubic phase (austenite) to orthorhombic plate (martensite) is considered. The comparison of the evanescent mode trajectories between the cubic and orthorhombic alloys shows the presence of imaginary modes in the cubic phase, although they may not exist in the orthorhombic phase at specific frequencies. In the case of Lamb propagation in the cubic alloy, the dispersion curves oscillate strongly, creating crossings among multiple symmetric and antisymmetric modes. This study also concerns the second harmonic generation of Lamb mode pairs in cubic and orthorhombic alloys. Furthermore, effect of uniaxial stresses on Lamb dispersion curves in both phases are also identified and discussed. The results obtained may promote understanding and optimization of novel acoustic devices made of anisotropic materials.

Novel mode-coupling vibrations of AlN thin film bulk acoustic resonator operating with thickness-extensional mode

General Existence of Flexural Mode Doublets in Nanowires Targeting Vectorial Sensing Applications

A Multiple Resonant Mode Film Bulk Acoustic Resonator Based on Silicon-On-Insulator Structures

Analytical and experimental study on the second harmonic mode response of a bulk acoustic wave resonator

Lateral Size-Dependence in UHF Mode-Coupled ZnO FBARs to Suppress Undesirable Eigen-Modes and Weaken Mounting Effect

Electrically Tunable Film Bulk Acoustic Resonator Based On Au/Zno/Al Structure

Spurious resonance suppression in gigahertz-range ZnO thin-film bulk acoustic wave resonators by the boundary frame method: modeling and experiment

Demonstration of Thin Film Bulk Acoustic Resonator Based on AlN/AlScN Composite Film with a Feasible Keff2

High speed surface acoustic wave and laterally excited bulk wave resonator based on single-crystal non-polar AlN film

Visible-light Photoresponse of AlN-based Film Bulk Acoustic Wave Resonator

Suppression of Spurious Lateral Modes and Undesired Coupling Modes in Frame-Like FBARs by 2-D Theory

Perturbation analysis of nonlinear responses caused by transverse modes in AlN FBAR based on 2D scalar wave model

Progress of Research on the Thin-film Bulk Acoustic Resonator

Nonlinear Coupling of Flexural Mode and Extensional Bulk Mode in Micromechanical Resonators

A novel oscillator based on film bulk acoustic resonator

High- Q film bulk acoustic resonator with high quality AlN film based on transfer method

P1J-5 Spurious Modes in Aluminum Nitride Film Resonators

Two-dimension Numerical Simulation of AlN Film Bulk Acoustic Resonator(FBAR)

The Characterization of Surface Acoustic Wave Devices Based on AlN-Metal Structures.

Propagating, Evanescent and ZGV Lamb Modes in High-Performance Anisotropic Cu–Al–Ni Alloy Plates

Study on the Spurious Modes in FBAR Resonators with Quasi-Free Edges