Abstract:Integrated opto-mechanical analysis (IOA) for Photoelectric detection and tracking systems (PDTS) is crucial both in the early design phase and during later operation and maintenance. The movements of PDTS typically generate unbalanced momentum, resulting in noticeable line-of-sight jitters (LOSJs) and wavefront aberrations (WFAs) of the beam. However, the characteristics of multidisciplinary coupling and multibody system dynamics bring challenges to the measurement of LOSJ and WFA. To address this challenge, this paper proposes a modeling method for the opto-mechanical coupling problems of PDTS during dynamic processes. Firstly, a flexible multibody system dynamics model of PDTS is constructed to assess its kinematics, dynamics, and mechanics performance. The reaction moments and their effect on deformation and equivalent stress are obtained. Secondly, an optical model is developed to make the mechanical data available in optical analysis. The LOSJ and WFA are computed by using homogeneous coordinate transformation and ray tracing. Then, an engineering experiment and a numerical experiment are carried out to validate the accuracy of the model. The results show that the average relative error of LOSJ is 4.452%, the R 2 of WFA is greater than 0.991, and the RMSE is less than 6.921 × 10 –3 , which verifies the accuracy and reliability of the proposed method. Finally, the multidisciplinary performance of PDTS under a dynamic condition is analyzed and discussed. The causes of LOSJ and WFA are clarified, and mitigation strategies for these phenomena are proposed. The proposed method and coupling analysis results have reference significance for the multidisciplinary design optimization and optoelectronic control of PDTS.

Optical Interference Phase Control Method with Single Photodetector for Interference Lithography.

An improved scheme and numerical simulation of segmented planar imaging detector for electro-optical reconnaissance

Analysis and Controller Design of Fringe Phase Locking System for Interference Lithography

Phase Error Correction by &Lt;inline-Formula><math Display="inline" Overflow="scroll"><mi>π</mi></math></inline-Formula>-shift Odd-Step Fringe Projection and Speckle Filtering in Phase Measuring Profilometry

Analysis and Design of Fringe Phase Control System for Scanning Beam Interference Lithography

Optimal Control for Stabilizing Fringe Phase in Interference Lithography

Electro-optic Modulator Feedback Control in Phase-Sensitive Optical Time-Domain Reflectometer Distributed Sensor.

Real-time Correction of Periodic Nonlinearity in Homodyne Detection for Scanning Beam Interference Lithography

Design of a synchronization control system for lithography based on repetitive control method

Nonlinear control of a piezoelectric actuator system for a phase shift interferometer

Progress on scanning beam interference lithography tool with high environmental robustness for patterning large size grating with nanometre accuracy

Topography of Integrated Circuits Detected by Phase Selection in Modulated Optical Reflectance Microscopy

Pixel-addressable Phase Calibration of Spatial Light Modulators: a Common-Path Phase-Shifting Interferometric Microscopy Approach

Error-based observation control of an image-based control loop for disturbance suppression in segmented lightweight large-scaled diffractive telescope (SLLDT)

Interference Confocal Microscope Integrated with Spatial Phase Shifter

Design and Control of Ultra-Precision Fine Positioning Stage for Scanning Beam Interference Lithography

Quantitative Phase Modulation Monitoring Based on a Shearing Interferometry Fringe Projection Method

A Phase Difference Measurement Method for Integrated Optical Interferometric Imagers

A modeling method for the opto-mechanical coupling problems of photoelectric detection and tracking systems in dynamics process

Programmable Pupil Correction Method for Photolithography Illumination System

Adaptive Modulation System for Optical Phase Profile