Abstract:In order to clarify the magnetic-thermal-force changing rule of high-frequency transformers under different winding arrangements, this paper tests the magnetization and loss characteristics of nanocrystalline materials at different temperatures, and based on the magnetization and loss data, establishes a magnetic-thermal-force coupling calculation model of 15 kVA, 5 kHz nanocrystalline high-frequency transformers, and calculates and analyzes the magnetic flux density, loss and temperature rise distributions of high-frequency transformers with three different winding arrangements under no-load and short-circuit conditions, respectively. Through comparative analysis, it was found that under no-load conditions, the cross-transposition of winding has less influence on the magnetic flux of the high-frequency transformer core, but it can reduce the iron-core loss and transformer temperature rise. The cross-transposition of winding under short-circuit conditions can significantly reduce the leakage magnetic field strength of high-frequency transformers; complete cross-transposition weakens the high-frequency transformer losses and temperature rise better than partial cross-transposition. According to the winding current density and core leakage field distribution under short-circuit conditions, we calculated and analyzed the distribution of its the axial and radial electromagnetic forces. The results show that the axial electromagnetic force causes the winding to be squeezed from both ends to the middle, the radial electromagnetic force causes the primary winding to shrink inward and the secondary winding to expand outward, so cross-transposition can greatly reduce electromagnetic force and weakening the deformation of the winding. Therefore, high-frequency transformers of winding cross-transposed should be used in actual projects to reduce transformer temperature rise and improve efficiency and security. This research has theoretical significance for the multi-physical field coupling of high-frequency transformers and its structural design.

Numerical Study on Low Pressure Discharge of Microwave Stepped Impedance Transformer

Research on Transient Electric Field Distribution of High-Frequency Transformers Based on COMSOL and SIMULINK Co-simulation

Dynamic Electromagnetic Force Analysis of a Power Transformer with Regulated Windings

Transient simulation of dielectric breakdown during high-power microwave propagation based on the SETD method

Transient Analysis of High-Power Microwave Air Breakdown under External DC Magnetic Field

Transient Simulation of Electromagnetic Wave Propagation in Plasma Based on Dynamic Drude Model

Numerical Studies of High Power Microwave Argon breakdown based on SETD method

Investigating Pressure Patterns in Transformer Tanks after an Interturn Short Circuit: A Finite Element Approach

Numerical simulation of waveguide plasma limiter under high power microwave based on the SETD method

Research on Magnetic-Thermal-Force Multi-Physical Field Coupling of a High-Frequency Transformer with Different Winding Arrangements

Simulation and Analysis of Transformer Oil Interface Discharge under DC Voltage

Numerical Studies of Light Brightness Emitted by Microwave Nitrogen Breakdown in Circular Waveguide

Gas Heating Analysis in High-Power Microwave Breakdown Process Based on SETD Method

Field Distribution, Hpm Multipactor, and Plasma Discharge on the Periodic Triangular Surface

Magneto-thermal coupling simulation and experimental verification for a three-winding high-frequency transformer

Numerical Investigations for Vibration and Deformation of Power Transformer Windings under Short-Circuit Condition

Electric Field Optimization of Cast Resin Dry-Type Transformer under Lightning Impulse

Partial Discharge Initiating Process of Transformer Oil under Combined AC and DC Voltage

The Propagation Characteristics Of Electromagnetic Wave Generated From Partial Discharges In Power Transformer By Fdtd Simulation

Emission Spectroscopy Diagnosis and Discharge Characteristics Distribution Analysis of High-Frequency, High-Enthalpy Inductive Coupling Plasma Generator

Numerical Studies of Dielectric Breakdown during High-Power Operation Based on SETD Method