Abstract:With the increasing complexity of distribution network structures originating from the high penetration of renewable energy and responsive loads, fast and accurate fault location technology for distribution networks is a prerequisite for rapid isolation of faults and restoration of the power supply. In this paper, a fault location method based on community graph depth-first traversal is proposed for fast location of single-phase ground faults in distribution networks. First, this paper defines the fault graph weight of the vertices in the distribution network graph model, which can be used to reflect the topology of the vertices and fault points as well as the fluctuation of the vertices' currents. Then, the vertices on the graph model are clustered by using an improved parallel louvain method (IPLM). Finally, the community formed by IPLM is used as the smallest unit for depth-first traversal to achieve fast and accurate location of the fault section. The paper develops a distribution network graph model of IEEE 33-bus system on the graph database for testing. And three other methods are selected for comparison with IPLMDF. The test results show that IPLMDF can achieve fast and accurate fault location when half of the nodes in the distribution network are equipped with D-PMUs. When some of the D-PMUs lose time synchronization, it is still possible to locate the fault section, and at the same time, the locating results can be avoided by falling into local optimal solutions.

Power Network Fault Location Based on Voltage Magnitude Measurements and Sparse Estimation

Power Network Fault Location with Exact Distributed Parameter Line Model and Sparse Estimation

PMU-Based Fault Location Using Voltage Measurements in Large Transmission Networks

Transmission network fault location using sparse PMU measurements

Novel Fault Locating Method Based on Synchronized Voltage Phasor

Block-Sparse Bayesian Learning Method for Fault Location in Active Distribution Networks with Limited Synchronized Measurements

State Estimation Based Fault Location Method for Active Distribution Networks

Fault Location in Active Distribution Networks Using Block Sparse Bayesian Learning

Fault Location in Active Distribution Networks Using Multiple Measurement-Based Bayesian Learning

A Two-Terminal Fault Location Algorithm Using Asynchronous Phasors Based on Distributed Parameter Model

An Efficient PMU-Based Fault-Location Technique for Multiterminal Transmission Lines

Physics-Informed Data-Driven Transmission Line Fault Location Based on Dynamic State Estimation

A new fault location algorithm based on fault component from finite synchronized phasor measurement unit

Precise Fault Location in Distribution Networks Based on Optimal Monitor Allocation

Accurate Fault Location Method of Distribution Network with Limited Number of PMUs

A Fault Branch Location Approach for Partially Observable Distribution Network

Research on Fault Location Based on Pmu for Multi-Source Distribution Network

Location of Asymmetric Ground Fault Using Virtual Injected Current Ratio and Two-stage Recovery Strategy in Distribution Networks

Fault Location Method for Distribution Network Based on Synchronous Measurement

Fast single-phase fault location method based on community graph depth-first traversal for distribution network

New Algorithm for 2-terminal Transmission Line Fault Location Integrating Voltage Phasor Feature and Phase Angle Jump Checking