Abstract:In this study, pure Mo and Mo-6Ta alloy targets were produced by a manufacturing method, which is called die pressing with a combination of cold isostatic pressing and hot-pressing sintering technology, and molybdenum thin films were deposited on corning glass substrates using a DC magnetron sputtering system. The effect of alloying with tantalum on the phase structure, grain size, orientation, thin film surface morphologies and electrochemical properties has been investigated by a variety of techniques such as X-ray diffraction (XRD), field emission scanning electron microscopy (FE-SEM) with electron back-scattered diffraction (EBSD), atomic force microscopy (AFM), four-probe resistivity tester, and electrochemical analyzer. The observation of the Mo targets reveals that this manufacturing technology with alloying of tantalum can reduce the target's grain size to lower than 50 μm with random grain orientation. The microstructure of the deposited Mo thin films indicates that the alloyed films have the higher deposition velocity with a dense fine grain structure and smoother surface. The sheet resistivity of the alloyed Mo film increases continuously with the increasing of the sputtering time, and eventually becomes higher than that of the pure Mo film. In electrochemical tests, both of the Mo films show capacitive reactance, and the capacitive arc radius of the alloyed Mo films are obviously larger than that of pure Mo films. The result of alloying with tantalum shows an increase in the corrosion potential of the Mo film from −0.5 V to −0.2 V, indicating improvement of the corrosion resistance of Mo films.

Microstructure, Properties, and Grain Growth Kinetics of Mo-5Ta Refractory Sputtering Targets Prepared by SPS

Densification, grain growth mechanism and mechanical properties of Mo-10Nb refractory targets fabricated by SPS

Characterization of Mo-6Ta alloy targets and its magnetron sputtering deposited thin film

Microstructural Evolution and Mechanical Properties of Spark Plasma Sintering of Tantalum-Tungsten Alloy

High-temperature Oxidation Behaviour of SPS-prepared Mo and Mo–5Ta Alloys

Microstructure evolution and densification during spark plasma sintering of nanocrystalline W-5wt.%Ta alloy

Microstructure and mechanical properties of Ta–Ti alloy by plasma-activated sintering

Effects of Mo target power on the structure and tribological properties of AlB2 Ta1-xMoxB films by magnetron sputtering

Sintering and densification mechanisms of tantalum carbide ceramics

Effects of Tantalum Concentration on the Microstructures and Mechanical Properties of Tungsten-Tantalum Alloys

Spark Plasma Sintering of W-10Ti Alloys: Microstructure, Properties and Grain Growth Kinetics

Spark Plasma Sintering of W-10Ti High-Purity Sputtering Target: Densification Mechanism and Microstructure Evolution

The process and mechanical properties of Nb–Si–Mo–Ti alloy prepared by spark plasma sintering

Spark Plasma Sintering of W-30Si Refractory Targets: Microstructure, Densification and Mechanical Properties

First-principles study on the mechanical properties and thermodynamic properties of Mo-Ta alloys

Effect of Mo on the morphology, microstructure and mechanical properties of NbTa 0.5 TiMo x refractory high entropy alloy fabricated by laser powder bed fusion using elemental mixed powders

Study on Plastic Deformation Behavior of Mo-10Ta under Ultra-High Strain Rate

Study on microstructure, optical and tribological properties of self-formed Ta oxide films

Fabrication of amorphous AlMo 0.5 NbTa 0.5 TiZr RHEA coatings and the impact of deposition temperature on microstructure and properties

Effect of Nitrogen Doping on Tribological Properties of Ta2O5 Coatings Deposited by RF Magnetron Sputtering

Remanufacturing of the Waste Refractory Mo–10Nb Sputtering Target by Spark Plasma Sintering Technology