Abstract:Grate-firing technology is widely used for biomass combustion for heat and power production due to its good fuel flexibility. However, grate boilers often suffer from high unburnout, low efficiency, and high emissions, and require optimization to improve their performance. The distribution of primary air along the grate length significantly affects combustion and pollutant formation behaviors in the furnace; however, this effect is often under-investigated and poorly quantified. In this study, combustion of corn stover in a 130 t/h grate boiler is investigated experimentally and numerically. To establish a reliable baseline computational fluid dynamics (CFD) model and provide valuable reference for modeling and optimizing this industrial grate boiler, this study first investigates the applicability of the commonly used gas-phase reaction models. The finite rate/eddy dissipation model is found to outperform other gas-phase reaction models such as eddy dissipation model and eddy dissipation concept, which well predicts the temperature and shape of the flame in both the kinetics-controlled primary combustion zone and the diffusion-controlled burnout zone and shows the best agreement with the measured and site observations. Then, the study simulates and quantifies the effects of different primary air distribution modes (uniform, staged and refined-staged) on combustion performance of the boiler. Compared with the uniform primary air distribution, both the staged and refined-staged primary air distribution show an obvious increase in the char burnout ratio, from 76.5 % to 87.8 % and 95.5 %, respectively. Furthermore, the CO concentration at the furnace outlet is remarkably reduced, from 3178 ppm to 2766 ppm and 1917 ppm, respectively. This demonstrates that reasonable air supply in the latter two primary air distribution cases facilitates complete combustion in both the fuel-bed and freeboard. Moreover, in the latter two cases, the temperature distribution in the freeboard becomes more uniform, and the local oxygen-rich regions are eliminated. These are beneficial in suppressing the NO formation, as the emission of which decreases from 172 mg/m3 (at 11 % O2) to 161 mg/m3 and 156 mg/m3, respectively. This work provides important theoretical guidance for the accurate modeling and optimization of grate-firing boilers as well as the design of new grate boilers.

Optimization of the Air Distribution in a Biomass Grate-Fired Furnace

Mathematical modeling of combustion in a grate-fired boiler burning straw and effect of operating conditions under air- and oxygen-enriched atmospheres

Optimizing Biomass Combustion in a 130 T/h Grate Boiler: Assessing Gas-Phase Reaction Models and Primary Air Distribution Strategies

CFD simulation and optimization of secondary air distribution for waste combustion in grate furnace

Efficient and Low-nor Combustion in a Grate-Fired Boiler by Feeding Biomass Non-Uniformly along Grate Width: an Integrated Modeling Study with Experimental Validation

Numerical Analysis of NOx Reduction in Large-Scale MSW Grate Furnace Through In-Bed Combustion Optimization Using Multi-Section Fuel Bed Model with Thermally Thick Treatment

Partitioning Primary Air to Strengthen Efficiently the Horizontal Air-Staging Conditions within a 75 T/H Coal-Fired Reversal Grate Furnace

Numerical simulation of effects of flue gas recirculation on biomass combustion in grate boiler

ICOPE-15-C078 Effects of Vent Air Angles on Combustion and NO Emission Characteristics for a Down-Fired 600MW Pulverized-Coal Utility Boiler Retrofitted with a Novel Combustion System

A Numerical Investigation of NOx Concentration at the Outlet of a Coal-Fired Chain Grate Boiler

A case study of biomass co-firing in a 55 MW pulverized coal fired furnace

Reduced Pollutant Emissions and Slagging Rate of Biomass Pellet Combustion by Optimizing the Multilayer Distribution of Secondary Air

Optimization of Operating Parameters for Low Nox Emission in High-Temperature Air Combustion

Experimental Study and Design of Biomass Co-Firing in a Full-Scale Coal-Fired Furnace with Storage Pulverizing System

Numerical Optimization Study of Combustion and Heat Transfer Characteristics in Municipal Solid Waste Incinerators

Industrial equipment optimization for combustion performance enhancement: a real-world case study

Numerical Evaluation of Heat Transfer and NOx Emissions under Deep-Air-staging Conditions Within a 600 MWe Tangentially Fired Pulverized-Coal Boiler

Revisit Flame Modulation Towards Low-Nox and Uniform Thermal Field in Heating Flue of a Coke Oven

Retrofit of a 600 MW Down-Fired Pulverized-Coal Furnace for Low NOx Emission

Characterization of Combustion and NOx Emissions with Respect to Overfire Air Damper Opening in a Down-Fired Pulverized-Coal Furnace

Optimization Study on Air Distribution of an Actual Agriculture Up-Draft Biomass Gasification Stove