Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

Dynamic Compliance of Measuring Device for Force on High-speed Rotors

Measurement Research of Motorized Spindle Dynamic Stiffness under High Speed Rotating

Measurement of Dynamic Performances of High-Speed Rotating Spindle by Non-Contact Electromagnetic Loading Device

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

A Rapid Complexity Evaluation Method of Mechanical Signals

Novel Electromagnetic Rotor Position Sensor for Brushless Dc Machine in Aviation and Aerospace Industry

High-accurate Cutting Forces Estimation by Machine Learning with Voice Coil Motor-Driven Fast Tool Servo for Micro/nano Cutting

Phase-Based Noncontact Vibration Measurement of High-Speed Magnetically Suspended Rotor.

High-speed rotating mechanism based on multi-sensor data fusion end face displacement determination method

Moire fringes-based measurement of radial error motion of high-speed spindle

Feasibility Investigation of Sinusoidal Radial Excitation Force Loading of High-Speed Motors

Dynamic loading tests of a high speed motorized spindle with magnetorheological fluid

Non-contact Electromagnetic Exciter Design with Linear Control Method

A Passive Non-Interference Scheme for Synchronously Measuring Multiple Parameters With Single Sensing Unit

Rotational Speed Measurement Through Electrostatic Sensing and Correlation Signal Processing

Moiré fringes-based measurement of radial error motion of high-speed spindle

Dynamic Performance Analysis of High Speed Motorized Spindle under Speed Sensor-less Vector Control

A high performance sensor for triaxial cutting force measurement in turning.

Optimization of Electrostatic Sensors for Rotational Speed Measurement of a Metallic Rotor

Research on the Field Dynamic Balancing Technology and Instrument for a High Speed Cantilever Rotor

Rotational Speed Measurement Using Single and Dual Electrostatic Sensors