Abstract:Bulk resistance of the gas diffusion layer (GDL) plays an important role in the ohmic loss of proton exchange membrane fuel cells (PEMFCs). This work represents the first direct experimental study and comparison of the bulk resistances during the compression process of commonly used commercial GDLs, carbon paper and carbon felt, from the perspective of the microstructure mechanisms. The in-situ X-ray tomography and a fiber tracing algorithm are used to obtain the microstructure characteristics of compressed GDLs. The through-plane (T-P) and in-plane (I-P) bulk resistances of GDLs are measured by the microelectrode probe measurement method and the four-point probe method, respectively. Then, their resistivities are calculated. For the T-P direction, the arrangement of fibers gradually becomes compact during the compression, arousing the nearly linear increase of fiber contact points. Thus, more and more conductive paths are constructed, inducing a rapid decline of the T-P bulk resistivity. Since the fibers in carbon felt are entangled together, the fibers in the edge areas are arranged loosely at low compression. This uneven distribution of contact points in carbon felt results in much larger T-P bulk resistivity than that of carbon paper at low compressive strain. For carbon paper, binders contribute significantly to the smaller T-P resistivity because they tend to gather at the fiber intersections, which forms more conductive paths with better conductivity. For the I-P direction, the bulk resistivities of GDLs decrease linearly during compression. The nearly horizontal fibers are the key to the I-P bulk resistivity, and both smaller fiber density and higher fiber tortuosity lead to the increase of the I-P bulk resistivity. This study helps to understand the microstructure mechanisms of the bulk resistances of various GDLs during the compression process, which can guide the design and fabrication process of GDLs.

Analysis of Lignocellulose and Microcrystalline Cellulose Densification in the Powder Bed During Gas Pressurization

Experimental Studies on Chopping Cotton Stalk when Compressed to High Densities

Comparative study on the compression characteristics under mechanical and gas pressurization

A COMPARATIVE STUDY OF CELLULOSE NANOWHISKERS (cnws) AND CELLULOSE NANOFIBERS (Cnfs)

Comparative Study on the Compression Characteristics of Coal and Biomass Powder Bed

Experimental research on the compression behavior of ultrafine alumina powders under gas pressurization

Compression Behaviour of Pulverized Coal under Gas Pressurization for the Gasification Process

Experimental Study on the Alumina Fine Powder Internal Compression Characteristics under Gas Pressurization

Effect of Powder Column Height on the Compression Behavior of Rice Husk Powder under Gas Pressurization

Compression and Consolidation Characteristics Analysis of Waste Tire Powder Bed During Gas Pressurization

Microstructures and electrical conductivity properties of compressed gas diffusion layers using X-ray tomography

Analysis of compression in uniform and non-uniform GDL microstructures on water transport

Influence of Thermocompression Conditions on the Properties and Chemical Composition of Bio-Based Materials Derived from Lignocellulosic Biomass

Discrete element method-computational fluid dynamics analyses of flexible fibre fluidization

Effect of Lignin on the Thermal Stability of Cellulose Nanofibrils Produced from Bagasse Pulp

A Numerical Study of Structural Change and Anisotropic Permeability in Compressed Carbon Cloth Polymer Electrolyte Fuel Cell Gas Diffusion Layers

A Numerical Study on Gas-Fluidized Beds of Wet Flexible Fibers

Effect of Clamping Compression on the Mechanical Performance of a Carbon Paper Gas Diffusion Layer in Polymer Electrolyte Membrane Fuel Cells

Physicochemical properties and microstructure of corn flour–cellulose fiber extrudates

Conveying mechanisms of dense-phase pneumatic conveying of pulverized lignite in horizontal pipe under high pressure

Gas-Pressurized Torrefaction of Lignocellulosic Solid Wastes: Deoxygenation and Aromatization Mechanisms of Cellulose