Abstract:In a regular FAIMS system, a carrier gas is used to drive samples through the drift tube. Thus, high consumption of sample and carrier gas can be expected, especially when multi-cycle detection is needed for high precision detection. In this study, a novel re-circulation mode FAIMS was developed. Ion separation capacity and limit of detection (LOD) of this FAIMS system were investigated. The stability of this FAIMS system was also studied by changing the flow rate of the carrier gas. Using this newly designed re-circulation mode FAIMS system, the detection results of o-, p- m- xylenes in pure nitrogen and helium/nitrogen mixtures were compared. The sample and the carrier gas reserve time which ensure the success of multi-cycle detection was examined. The characteristic parameters (alpha(2), alpha(4)) and their deviation were also precisely calculated through 18 CV-DV spectra. Results show that 0.6 ng o-xylene can be detected in a 25 ml closed loop re-circulation arrangement. The effective detection time is 6.2 min in this detection process. In fact, the sample and the carrier gas used in this experiment are 70 and 826 times less than a regular open loop FAIMS system respectively. The peak position and the full width at half-maximum (FWHM) of the obtained CV-DV spectra stay almost unchanged during th.entire experiment process. The ion signal peaks can be fitted with a Gauss curve, which means that the stability of the carrier gas flow rate fully meet the requirement for on-site detection. Furthermore, the use of a helium modifier is studied and proved to be an effective method to improve the detection capacity of the FAIMS for VOCs. In conclusion, the gas-saving re-circulation design along with the gas modifiers provide new opportunities for FAIMS systems to be applied on-site high precision chemical detection. (C) 2016 Elsevier B.V. All rights reserved.

Design and Performance of a Dual Stage Asymmetric Ion Funnel Interface

Design and study of an atmospheric pressure ion funnel by computer simulations

Gas Modifier Assisted Re-Circulation Mode High-Field Asymmetric Waveform Ion Mobility Spectrometry (FAIMS)

Sensitivity and Robustness Enhancements by Using a V-Shape Ion Funnel in FTICR-MS

Design of an atmospheric pressure ionization vacuum interface and its application on electrospray ioniza-tion time-of-flight mass spectrometer.

Characterization of a discontinuous atmospheric pressure interface. Multiple ion introduction pulses for improved performance

On an aerodynamic mechanism to enhance ion transmission and sensitivity of FAIMS for nano-electrospray ionization-mass spectrometry

A Miniature Orthogonal Injection Ion Funnel (MO-IF) Providing Enhanced Performance for the Miniature Mass Spectrometer

Design and Simulation of the Miniaturized Ion Funnel

Characterisation and optimisation of ion discrimination in a mini ion funnel for a miniature mass spectrometer

Simulation Study of Three New Quadrupole Ion Funnels to Improve Low-Mass Ion Transmission.

Evaluation of a New DC-Ion Funnel Drift Tube for Use in Proton Transfer Reaction Mass Spectrometry

Corona Discharge Ionization Source for A Planar High-Field Asymmetric Waveform Ion Mobility Spectrometer

Study of discontinuous atmospheric pressure interfaces for mass spectrometry instrumentation development.

Research Progress and Application of Ion Funnel Technique

Mini Mass Spectrometer Integrated with a Miniature Ion Funnel

Utility of Multi-Functional Two Channel Off-Axis Ion Funnel (TCOAIF) in FTICR-MS

Ion transfer between ion source and mass spectrometer inlet: electro-hydrodynamic simulation and experimental validation

Design, Fabrication and Mass-spectrometric Studies of a Micro Ion Source for High-Field Asymmetric Waveform Ion Mobility Spectrometry

Design of a selective interface for electrospray ionization-mass spectrometry.

High-sensitivity Ion Mobility Spectrometry/mass Spectrometry Using Electrodynamic Ion Funnel Interfaces.