Abstract:In order to improve the capacity of beam collimation for laser beam expander, it is necessary to design a more reasonable and feasible structure of beam expander system. Laser beam expander is used to compress the laser divergence angle, in order to reduce the energy losing in long distance scanning acquisition system. This paper introduces the working principle and design idea of the laser beam expander, the collimating multiplying power focal length and the collimated magnification formula of expander main, secondary mirror. According to the third-order aberration theory, Considering the spherical aberration, sine difference and divergence angle, the reasonable analysis of optical path, ZEMAX optical design software was used to design large-diameter laser beam expander and analysis and optimize, And given the actual design data and results. Display the maximum optical path difference is +/- 0.001 lambda of the main light ray and each light ray. To combination the rear-group objective lens of Galileo and Kepler beam expander, a large-diameter( 1.475m) laser beam expander was designed with 0.2m in the diameter, 1/2m in the relative caliber. In the objective lens System, a high-order aspherical was used to the aberration of extra-axial point. we can see that the image quality is close to the diffraction limit from the curves of wavefront. In addition to improve image quality effectively, the system has the characteristics of simple structure, less costly and less design difficulty to compare with the other beam expanding system. And make the output beam's divergence angle smaller, energy density higher, and the beam quality has been greatly improved. The results show that the beam expander is fully meet the design requirements, the use effect is good. Design and research of laser beam expanding system not only improves the quality of the laser beam in the laser system, but also enlarge the application field of laser technology in photoelectric system.

Three-dimensional Printing of a Beam Expander to Enable the Combination of Hundred-Micron Optical Elements and a Single-Mode Fiber.

3D nanoprinting for fiber-integrated achromatic diffractive lens

Single- and multi-layer micro-scale diffractive lens fabrication for fiber imaging probes with versatile depth-of-field

Fiber-integrated Hybrid Achromatic Microlenses by Combined Femtosecond Laser 3D Printing

Nanoimprint of a 3D structure on an optical fiber for light wavefront manipulation

Three-dimensional microfabrication through a multimode optical fiber

Diffractive Micro-Optical Elements for Implementing Hollow Beam and Bi-Focus Simultaneously

Fabrication of optical components with nm- to mm-scale critical features using three-dimensional direct laser writing

3D High Precision Laser Printing of a Flat Nanofocalizer for Subwavelength Light Spot Array

Optical Design of Multi-Stage Confocal Parabolic Reflection Laser Beam Expander

3D Printing Mesoscale Optical Components with a Low-Cost Resin Printer Integrated with a Fiber-Optic Taper

Combining one and two photon polymerization for accelerated high performance (3+1)D photonic integration

3D printing of polymeric optical components by two-photon polymerization

Femtosecond laser 3D printed micro objective lens for ultrathin fiber endoscope

Liquid Crystal Beam Shaping Device Based on Fiber End-Facet

Millimeter-Wave Beam Transforming Lens with 3D Printing Technology

Amplitude-phase Optimized Long Depth of Focus Femtosecond Axilens Beam for Single-Exposure Fabrication of High-Aspect-ratio Microstructures

Fabrication of beam shapers in the bulk of fused silica by femtosecond laser pulses.

Study And Design Of Beam Expander With Wide Aperture

Fabrication of Embedded Microball Lens in PMMA with High Repetition Rate Femtosecond Fiber Laser.

Optical-digital joint design of multi-order diffractive lenses for lightweight high-resolution computational imaging