Abstract:The amount of heat loss through thermal bridges increases with the improvement of the thermal insulation performance of the building exterior wall, making thermal bridges vulnerable points of thermal insulation. The wall-to-floor thermal bridge (WFTB) takes the most considerable fraction on the building envelope and has the largest heat flux. In this study, we aimed to (1) develop a new method to evaluate the insulation performance of the WFTB, which is easier to implement in engineering, and (2) propose a strategy to reduce heat loss due to the WFTB. The apparent thermal resistance of the WFTB (R-TB), which is affected by the thermal resistance of the wall (R-W) and the insulation layer (R-I), was defined to quantify the effects of the building envelope material on the thermal performance of the WFTB. Numerical simulations and full-scale (1:1) experiments were conducted to investigate the insulation performance of the WFTB under different conditions. The results indicated that R-TB increased monotonously with an increase in R-I. However, the increase became slower with an increase in R-I, indicating that improving the insulation performance of the insulation layer cannot effectively improve RTB when R-I is relatively high. Additionally, the changing rate of RTB with respect to R-W varied among different R-I values, indicating that R-W and R-I have a synergistic effect on R-TB. An empirical formula was obtained for calculating R-TB using R-W and R-I. WFTBs in different buildings can be analyzed using this formula. Suitable insulating materials for optimizing the performance of WFTBs can thus be identified at the design stage for new buildings and the renovation of existing buildings. (C) 2020 Elsevier B.V. All rights reserved.

A Novel Response Factor-Based Method for in Situ Measurement of Wall Thermal Resistance

Methods for Evaluating and Improving Thermal Performance of Wall-to-floor Thermal Bridges

In-situ measurement of thermal transmittance of building walls: Evaluation of stored heat flux in heavy-weight walls during the cooling season

A data analysis method for detecting wall thermal resistance considering wind velocity in situ

Heat and Moisture Transfer in Wall-to-floor Thermal Bridges and Its Influence on Thermal Performance

Numerical Study on Wall Insulation Construction Affecting the Energy Consumption under the Intermittent and Loculose Energy Use

Comparison between Heat Flow Meter (HFM) and Thermometric (THM) Method for Building Wall Thermal Characterization: Latest Advances and Critical Review

In situ methodology for thermal performance evaluation of building wall: A review

A Novel AI-Based Thermal Conductivity Predictor in the Insulation Performance Analysis of Signal-Transmissive Wall

Measuring the effective thermal resistance of ventilated air-spaces behind common wall assemblies: Theoretical uncertainty analysis and recommendations for the hot box method modifications (ASHRAE 1759-RP)

A response factor method to quantify the dynamic performance for pipe-embedded radiant systems

Non-Destructive Possibilities of Thermal Performance Evaluation of the External Walls

A Novel Thermal Response Factor Method for the Dynamic Load Calculation of Buildings

In-situ virtual heat flow meter model for monitoring heat flux of existing building envelope

Numerical and experimental analysis of building walls thermal performance

Estimation of the thermal properties of an historic building wall by combining Modal Identification Method and Optimal Experiment Design

Analytical Optimization of the Transient Thermal Performance of Building Wall by Using Thermal Impedance Based on Thermal-Electric Analogy

A New Method of Pixel-level In-situ U-value Measurement for Building Envelopes Based on Infrared Thermography

Quantitative internal infrared thermography for determining in-situ thermal behaviour of façades

Modeling Analysis and Experimental Study of a Temperature-difference Type Heat Flux Meter

Simultaneous estimation of hygrothermal properties of a prefabricated lightweight wall using one-year on-site measurements to solve inverse problems