Abstract:Utilizing passive electromagnetic interference (EMI) filters is the most widely used approach to restrain the conducted emissions from power converters. However, the introduction of these filters will significantly raise the weight and size of the systems. Using the emerging flexible multi-layer foil (FMLF) technique, this article investigates a complete electromagnetically integrated design concept of single-phase EMI filters based on EE-type cores, which can be applicable to engineering application scenarios with different EMI noise attenuation requirements. Two types of integrated structures are constructed with different well-designed FMLF-windings and terminal configurations. One is a common-mode (CM) choke with controllable leakage inductances, which is able to realize the integration design of CM inductor, CM capacitors and differential-mode (DM) inductors. The other is an EMI choke with integrating the CM and DM inductances and capacitances, which achieves electromagnetic integration of all the CM and DM filtering components. Compared to the existing UU-type core based integration methods, the proposed methods can ameliorate the noise suppression performance while reducing filter's weight and volume. Theoretical analyses for modeling and design of the EMI chokes is presented. Then prototypes of different FMLFs-based EMI filters have been built for a 500 W 100 kHz SiC- mosfet inverter, experiments demonstrate the feasibility and validity of the proposed structures.

Design and Implementation of a New Hybrid EMI Filter for DC-DC Converter with SiC MOSFETs

Hybrid SiC-Si DC–AC Topology: SHEPWM Si-IGBT Master Unit Handling High Power Integrated with Partial-Power SiC-MOSFET Slave Unit Improving Performance

Design of Ac/dc Converter for Bidirectional On-Board Battery Charger with Minimizing the Amount of SiC MOSFET

Design of Low Parasitic Inductance SiC MOSFETs Halfbridge Power Modules

A Systematic Design and Optimization Technique for the Suppression of EMI Common Mode (CM) Noise

PFC converter with novel integration of both EMI filter and Boost inductors

Implementation of a MOSFET-based active differential mode EMI filter in DC/DC converter

Integration of Both EMI Filter and Boost Inductor for 1-Kw PFC Converter

Design and Experiment Research of Integrated EMI Filter Based on Flexible Multi-Layer Foils

An Extremely High Efficient Three-Level Active Neutral-Point-Clamped Converter Comprising SiC and Si Hybrid Power Stages

Full Electromagnetic Integration of Impedance-Balanced EMI Filters for Single-Phase Power Converters

Modeling and Design of Full Electromagnetic Integration of a Symmetrical EMI Filtering Circuit with Flexible Multi-Layer Foil Technique

A PFC Converter With Novel Integration of Both the EMI Filter and Boost Inductor

An SiC MOSFET & Si Diode Hybrid Three-Phase High-Power Three-level Rectifier

High efficiency power factor correction power supply based on SiC device

A Three-Phase-Module-Parallel Si & SiC Hybrid Inverter with Smaller Filter Size and Low Cost

Analysis and Suppression of Common-Mode EMI Noise in 1 MHz 380 V-12 V DCX Converter with Low NFoM Devices

Electromagnetic Integration of a Symmetrical LCL-EMI Filter for Grid-Connected Voltage-Source Converters

A Control Method for the Interleaved Active Power Filter with SiC-MOSFETs

Analysis and Suppression of Common-mode EMI Using Synchronous Pulsed Compensation in Power Electronics

An Advanced Design of Power Module with EMI Reduction Method