Abstract:Timbers of the buildings are commonly covered with coatings to increase the fire retardancy. Compared with the current flame retardant coating, the traditional coating used in Chinese heritage buildings is much thicker and mainly acts as the thermal barrier plate. However, this kind of coatings could easily crack and flak affected by the environmental influences, which reduces the Heat insulation property of the timber. In this study, ignition and downward flame spread over wood boards were conducted by varying the gap (from 0 mm to 100 mm) and orientation (Vertical and Horizontal) of the Thermal Barrier Plate (TBP) under a constant external radiative heat flux to analyze the effect of cracking gap and direction of the coating on the ignition and downward flame spread of vertical timber components in heritage buildings. The results showed that the ignition time follows an 'inverse N-shaped' trend with the increasing gap of TBPs, which sequentially controlled by effects of solid phase heat loss, pyrolysis gas convection blockage effect formed by the waveform wall formed by the protruding TBPs and plenty fuel supply. There is a critical gap (about 6 mm) existing as the transition point. If the gap is below the critical value, the ignition time of horizontal orientation is shorter, and if it exceeds the critical value, the ignition time of the vertical orientation is shorter. In addition, the crossing flame spreading rate, which indicates that the speed of the upward flame cross the middle thermal barrier plate zone ignite the lower wood board, shows a 'N-shaped' trend with increasing TBP gap, due to the similar controlling mechanisms to the ignition time, and for the vertical orientation it is consistently greater than that of the horizontal orientation. The flame fails to spread across the middle TBP zone and the wood board extinguishes when the TBP gap and the fuel mass flux both below the critical values.

Experimental study on burn-through behavior of vertical wood board in the early fire stage

Experimental investigations on transient burning characteristics of a butt-jointed wooden wall with horizontal gaps in timber buildings

Experimental and Numerical Investigations on Fire Development in a Timber-Based Compartment with Identification of Characteristic Events

Experimental of Thermal Degradation and Ignition of Wood by Thermal Radiation

An Experimental Investigation on Char Pattern and Depth at Postflashover Compartments Using Medium-Density Fibreboard (Mdf)

Experimental Research on Moisture Transfer, Burning and Charring Behavior of Glue Laminated Larch Under Fire Heating Using Cone Calorimeter

EXPERIMENTAL STUDY ON CHARACTERISTICS OF FLAME SPREAD OVER THE SURFACE OF WOOD SHEETS WITH DIFFERENT WIDTH UNDER DIFFERENT INCLINED ANGLE

Thermal Behavior of Wood Slab under a Truncated-Cone Electrical Heater: Experimental Observation

Effect of Gap and Orientation of Thermal Barrier Plates on Ignition and Downward Crossing Flame Spread Over a Wood Board

Investigation on the double-sided concurrent flame spread behavior of log planks

Investigation on the burning behaviors of the combustible ceiling with the impingement of an incipient fire source

A Comparative Experimental Study on Heat Release Rates of Charring and Noncharring Solid Combustible Materials

Experimental Study of the Burning Behaviors of Thin-Layer Pool Fires

Experimental and Numerical Studies on the Fire Performance of Thin Sustainable Wood-Based Laminated Veneers

Experimental Study on Effects of Burning Behaviours of Materials Caused by External Heat Radiation

Effect of unheated length on heat transfer in a vertically solid burning

The Influence of Different External Heating Ways on Pyrolysis and Spontaneous Ignition of Some Woods

Experimental evaluation of combustion performance in the three main anatomical sections of poplar wood

Experimental Study of the Influence of Selected Factors on the Particle Board Ignition by Radiant Heat Flux

A study on wood pyrolysis and combustion characteristics using a thermal balance for simulating typical fire conditions

Experimental study on burning behaviors and thermal radiative penetration of thin-layer burning