Abstract:Cone calorimeter tests were conducted to investigate the moisture transfer, burning and charring behavior of timber under fire heating. 99 × 99 × 50 mm glue laminated larch specimens were made in cross grain and straight grain directions. The initial average moisture contents were 15.1 wt. % (cross grain specimens) and 13.5 wt.% (straight grain specimens). Twenty specimens were heated at 50 kW/m 2 of irradiance. Heating duration was varied between 10 to 50 min. Internal temperatures, surface temperature, heat release rate, and moisture contents were measured during heating. Charred depth, colored depth and burnt-out depth was measured after cooling. Heat release rate was measured by oxygen consumption method. Temperature was measured by an IR camera and thermocouples. Moisture content was measured by the electrical resistance method. Charring and coloring temperatures were estimated by using the measured charred or colored depth data and temperature histories. Burnt-out depth, charred depth and colored depth were slightly larger in case of straight grain specimens than that in cross grain specimens. Heat release rates were almost constant after reaching the first peak values. Temperature creep was observed in each location at about 100°C, according to evaporation of water. Maximum internal temperature of each specimen at each location increased while heating duration increased. Peak value of moisture content varied by each specimen, but the temperatures corresponding with peak moisture content were almost the same, i.e., around 100°C to 120°C. Moving speed of moisture peak is about 1.30 mm/min. Charring and coloring temperature were about 380 and 260°C, respectively.

Thermal Behavior of Wood Slab under a Truncated-Cone Electrical Heater: Experimental Observation

A mathematical description of thermal decomposition and spontaneous ignition of wood slab under a truncated-cone heater

Experimental of Thermal Degradation and Ignition of Wood by Thermal Radiation

Theoretical and Experimental Study on Transient Measurement of Wood Thermal Properties

Structural Deformation of Woody Slab During Pyrolysis and Combustion

Kinetic Study of Thermal Decomposition and Combustion Characteristics of Wood under Thermal Radiation

The Influence of Different External Heating Ways on Pyrolysis and Spontaneous Ignition of Some Woods

Experimental study on burn-through behavior of vertical wood board in the early fire stage

Experimental Research on Moisture Transfer, Burning and Charring Behavior of Glue Laminated Larch Under Fire Heating Using Cone Calorimeter

Thermal Responses of Woods Exposed to High Temperatures Considering Apparent Thermo-Physical Properties

Nonisothermal Thermogravimetric Kinetic Investigations On Combustion Behaviors Of Concomitant Biomass From Urban Plants

PREDICTING THE TEMPERATURE DISTRIBUTION OF WOOD EXPOSED TO A VARIABLE HEAT FLUX

Modeling Pyrolysis of Wet Wood under External Heat Flux

Experimental and Numerical Investigations on Fire Development in a Timber-Based Compartment with Identification of Characteristic Events

Experimental investigations on transient burning characteristics of a butt-jointed wooden wall with horizontal gaps in timber buildings

Thermal-balanced integral model for pyrolysis and ignition of wood

Smouldering Limit in Frictional Heating of Wood - Pilot Study

Pyrolysis and Ignition of Wood by Thermal Radiation

A study on wood pyrolysis and combustion characteristics using a thermal balance for simulating typical fire conditions

Ignition Characteristics of Typical Fitment Wood

Wood-burning processes in variable oxygen atmospheres: Thermolysis, fire, and smoke release behavior