Abstract:The inhibitor complex produced by the binding of alpha-D-glucose 1-phosphate 6-vanadate to the dephospho form of muscle phosphoglucomutase exhibits an unusually small dissociation constant: about 15 fM for the Mg2+ enzyme at pH 7.4, when calculated in terms of the tetraanion. Such tight binding suggests that the enzyme/vanadate/glucose phosphate complex mimics a state that at least approaches the transition state for (PO3-) transfer in the normal enzymic reaction. This hypothesis also is supported by the observation that replacement of Mg2+, the normal metal ion activator, by Li+, a poor activator, substantially reduces the binding constant for the glucose phosphate/vanadate mixed diester. Other indicators that support this hypothesis are described. One is the derived equilibrium constant for replacement of a PO4(2-) group in bound glucose bisphosphate by VO4(2-): 3 x 10(6) when the replaced group is the phosphate at the (PO3-) transfer site of the Mg2+ enzyme--in contrast to about 10 for the same replacement (of PO4(2-) by VO4(2-)) in an aqueous solution of a phosphate ester. Another is the greatly decreased rate at which Mg2+ dissociates from the glucose phosphate/vanadate complex of the enzyme, relative to the rate at which it dissociates from the corresponding bisphosphate complex (rate ratio less than or equal to 3 x 10(-4)), presumably because Mg2+ binds more tightly to the glucose phosphate/vanadate complex than to the corresponding bisphosphate complex. This apparent increase in Mg2+ binding occurs in spite of what appears to be a reduced charge density at the bound vanadate grouping, relative to the bound phosphate grouping, and in spite of the somewhat weaker binding of Mg2+ by dianionic vanadate than by the phosphate dianion. Although a direct assessment of the binding constant for Mg2+ was not possible, the equilibrium constant for Mg2+/Li+ exchange could be evaluated for the complexes of dephospho enzyme with glucose bisphosphate or glucose 1-phosphate 6-vanadate. The results suggest that the glucose phosphate/vanadate complex of the Mg2+ enzyme mimics a state about halfway between the ground state and the transition state for (PO3-) transfer. This estimate also is in accord with the binding of glucose phosphate/vanadate relative to that expected for transition-state binding of glucose bisphosphate. A possible scenario for the (PO3-) transfer catalyzed by the Mg2+ form of phosphoglucomutase is discussed, on the basis of these observations, together with possible reasons why the bound vanadate group appears to mimic an intermediate state for (PO3-) transfer rather than the ground state for phosphate binding.

Numerical Simulation and Casting Experiments on Particle Dispersion in 2219 Al Alloy by Introducing Al–5Ti–1B and Ultrasonic Treatment

Effects of ultrasonic vibration on the microstructure and mechanical properties of high alloying TiAl

Effect of ultrasonic melt processing and Al-Ti-B on the microstructural refinement of recycled Al alloys

Numerical Simulation of Grain Selection Behavior of Single Crystal Ni3al Based Superalloy Casting

Effects of Reinforcement Content and Homogenization Treatment on the Microstructure and Mechanical Properties of in-situ TiB2/2219Al Composites

Effect of TiC Nano-treating on the Fluidity and Solidification Behavior of Aluminum Alloy 6063

Investigation of Grain Refinement and Mechanical Properties of Al-7Si Alloy with Al-5Nb-1B Master Alloy Addition Treated by Ultrasound Treatment

Promoting Strengthening and Grain Refinement of Aluminum Alloy During Wire and Arc Additive Manufacturing by Adding TiB2 Particles

Numerical Simulation of Temperature Field and Grain Structure in Cu-10Al Alloy Produced by Heated Mould Continuous Casting

Effect of high cooling rate on the solidification microstructure of Al-Cu/TiB 2 alloy fabricated by Freeze-Ablation casting

Numerical Simulation of Temperature Field and Grain Texture During Casting Single Crystal Superalloy DD403 with Liquid Metal Cooling

Numerical Simulation and Experimental Casting of Nickel-Based Single-Crystal Superalloys by HRS and LMC Directional Solidification Processes

Numerical modeling and simulation of water cooling-controlled solidification for aluminum alloy investment casting

Effect of Ti content on microstructures and mechanical properties of cast Al-2Li-2Cu-0.5Mg alloy

Novel method to achieve synergetic strength–ductility improvement of Al–Cu alloy by in situ TiC–TiB2 particles via direct reaction synthesis

Effects of Al-Ti-C Refiner and Forming Processes on the Microstructure and Properties of Al-Zn-Mg-Cu Alloys

Characterization of a vanadate-based transition-state-analogue complex of phosphoglucomutase by kinetic and equilibrium binding studies. Mechanistic implications.

Formation of In-Situ Dispersion Strengthening Particles in Cast Fecral Alloy

Numerical Simulation and Experimental Investigation of Microstructure Evolution and Flow Behavior in the Rheological Squeeze Casting Process of A356 Alloy

Insights into the dual effects of Ti on the grain refinement and mechanical properties of hypoeutectic Al–Si alloys

On the strengthening effect of Al-Cr-Si dispersoid in an Al-Si-Mg-Cu casting alloy with Cr addition