Abstract:Photovoltaic (PV) power generation plant with integrated battery energy storage (BES) is becoming increasingly attractive and necessary as the PV penetration increases. Traditional solutions involve two paralleled inverter systems at the same site. This increases the balance of the system cost and the control complexity. Furthermore, high-power step-up transformers are needed to connect to the distribution grid, further increasing the capital cost, land use, and installation cost. Combining PV and BES into a single inverter system without the 60-Hz step-up transformer is, therefore, very attractive as the next-generation technology for utility-scale solar. This effectively calls for the development of a PV+BES solid-state transformer (PVS-SST). This article proposes a 13.8-kV/3-MVA PVS-SST targeting a 13.8-kV grid connection on the ac side and a 1500-V PV farm on the dc side. The PVS-SST utilizes a modular SST concept with a total of 27 SiC submodules. Each submodule is based on 1700-V SiC power MOSFET devices and single-stage dual-active-bridge (DAB)-based dc/ac power conversion technology. In order to utilize the inevitable parasitic capacitances in the actual hardware, a novel turn-off loss model is proposed and experimentally verified. A comprehensive optimization strategy, including the proposed novel turn-off loss model, ZVS range, dead-time calculation, and minimum circulation current, is proposed. The medium-frequency transformer (MFT) design to achieve very high efficiency and isolation voltage is a grand challenge in the proposed PVS-SST and is discussed in detail. The power density of the SiC power submodule is 1.6 MW/m3 (26 W/inch3). The PVS-SST control architecture is discussed with a focus on voltage balancing and real and reactive power controls.

Magnetic Design of a 4.16 Kv/1 MW Medium Voltage PV Plus Storage Solid State Transformer (PVS-SST)

35 Kj/7 Kw Conduction-cooled High Tc Superconducting Magnet Energy Storage

Hardware Design of a 13.8-Kv/3-mva PV Plus Storage Solid-State Transformer (PVS-SST)

Design And Demonstration Of A Sic-Based 800-V/10-Kv 1-Mw Solid-State Transformer For Grid-Connected Photovoltaic Systems

The Design and Experiments of the Four-modular Converters Power Control for Superconducting Magnetic Energy Storage System

Design and Testing of a Medium Frequency Transformer

Design and Optimization of a 200-Kw Medium-Frequency Transformer for Medium-Voltage SiC PV Inverters

Modeling and Design of a Medium Frequency Transformer with High Isolation and High Power-Density

Design of a High-Voltage-Insulation and High-Efficiency Medium Frequency Transformer

High-voltage High-Frequency Transformer Design for a 7.2kv to 120V/240V 20kva Solid State Transformer

Design of a 200 kW Medium-Frequency Transformer (MFT) With High Insulation Capability

Current and Voltage-Balancing Control of A Grid-Connected Single-Stage Modular PV Plus Storage Solid State Transformer (PVS-SST)

A High Power 200kW Medium Frequency Transformer With Improved Thermal Management

Application of Modular Multilevel Converter in Medium Voltage High Power Permanent Magnet Synchronous Generator Wind Energy Conversion Systems

500Kva Hybrid Solid State Transformer (HSST): Design and Implementation of the SST

Design and Demonstration of a 3.6kv–120v/10kva Solid State Transformer for Smart Grid Application

Design and Implementation of High Efficiency Control Scheme of Dual Active Bridge Based 10 Kv/1 MW Solid State Transformer for PV Application

A Novel High Insulation 100 Kw Medium Frequency Transformer

Design and Operation of A 3.6kv High Performance Solid State Transformer Based on 13kv Sic Mosfet and Jbs Diode

Three-phase Voltage Source Converters Based on Series-Connected Power devices for Medium Voltage Variable Speed Drives.

Modeling and Design of Insulation Structure for High Power Density Medium Voltage High-Frequency Transformers