Abstract:The outstanding potential of microwave resonator-based energy-efficient gas sensors has been overshadowed by their underperforming gas sensing capabilities, especially insignificant sensitivity to detect low-concentration volatile organic compounds (VOCs). This unmet challenge persists primarily due to predominant metallic resonator structures, which further limit their wearable applications and pose environmental concerns. This work presents a laser-induced graphene (LIG)-enabled split-ring resonator (SRR) sensor on a flexible polyimide substrate for the rapid and sensitive detection of gaseous VOCs. To implement the sensor, the conductive traces of the SRR were created using a computer-controlled CO2 laser at an optimized power level, thus inducing 48 mu m thick, conductive (24 S/cm) graphene layers on a polyimide substrate. The SRR gas sensor, in which LIG with three-dimensional networks of porosity serves as conductive and even gas-sensitive traces, benefits from a significantly enhanced interaction between the SRR's electromagnetic field and VOC gases. As a proof of concept, a prototype of the LIG-enabled SRR was implemented and mounted on a test fixture. The developed gas sensor operated at a resonant frequency of 1.402 GHz, which exhibited rapid (similar to 17 s) and noticeable shifts when exposed to 200 ppm of different VOCs (acetone, ethanol, methanol, toluene, and isopropyl alcohol). Additionally, the sensor demonstrated a linear correlation between the resonant frequency and acetone gas concentration (1 ppm-200 ppm), with a sensitivity of 188 KHz/ppm. These electromagnetic and gas sensing results suggest that polyimide-derived LIG traces can replace metal microstrip lines in the SRR structure, opening up possibilities for high-performance microwave resonator gas sensors, even suitable for flexible and wearable applications.

Noise Canceled Graphene-Microcavity Fiber Laser Sensor for Ultrasensitive Gas Detection

Gas Detection in a Graphene Based Dual-Mode Fiber Laser Microcavity

A Monolithic Graphene Functionalized Microlaser for Multispecies Gas Detection

Brillouin lasers in a graphene microresonator for multispecies and individual gas molecule detection

Graphene-Enhanced Brillouin Optomechanical Microresonator for Ultrasensitive Gas Detection.

Graphene-sensitized microring gas sensor probing with a single-wavelength laser

Selective Multiple Gas Tracing Using Graphene Based Microlaser Sensor

Fiber Interrogated and Graphene Enhanced Brillouin Optomechanical Microresonator for Ultra-Sensitive Gas Detection

Dual-mode Heterodyne Gas Tracing in a Graphene-Based Fiber Laser Microresonator

Electrically Tunable Four-Wave-Mixing in Graphene Heterogeneous Fiber for Individual Gas Molecule Detection

Ultra-compact Organic Vertical-Cavity Laser with High-Contrast Grating Feedback for Gas Detection

Ultra-Sensitive Absorption-Based Gas Detecting Using Graphene-Covered Periodic Photonic Crystal Slabs Resonating Under Critical Coupling Condition at Mid-Infrared Frequencies

Graphene based surface plasmonics in microfiber multimode interferometer for gas sensing

Photothermally Stabilized Fabry-Perot Cavity with Patterned Nanofilm for Photoacoustic Trace Gas Sensing

Hybrid Graphene-Microfiber Waveguide for Chemical Gas Sensing

Design of a Dual-Mode Graphene-on-Microring Resonator for Optical Gas Sensing

Patterned Laser-Induced Graphene Enabling a High-Performance Gas Sensing Split-Ring Resonator

Graphene-coated microfiber Bragg grating for high-sensitivity gas sensing.

Graphene-Based Microfiber Gas Sensor

Graphene Enhanced Evanescent Field in Microfiber Multimode Interferometer for Highly Sensitive Gas Sensing.

Graphene-based D-shaped Fiber Multicore Mode Interferometer for Chemical Gas Sensing.