Abstract:The intensity of photoacoustic signal is proportional to optical power. However, high power laser source has many disadvantages, such as high power consumption, complex driving and controlling circuit, the lasers with high quality and lower cost laser can't be attained easily. These kinds of laser source mostly focus on the band over 6 micron, which makes it difficult to detect the molecule in fundamental absorption band of 2 similar to 6 micron effectively. Moreover, photoacoustic gas sensors based on commercial driving and controlling instruments are more likely to have large volume, which can't meet the needs of multi-points and continuous mobile monitoring. In this paper, nmol . mol(-1) level measurement applied to molecule concentrations was realized in 3 similar to 4 micron band using low output power interband cascade laser (ICL) and a detection method which based on quartz tuning fork and photoacoustic spectroscopy. The ICL was used to target a strong ethane absorption ling at 2 996.88 cm(-1) in its fundamental absorption band. High sensitive detection and system volume reduction were realized by using self-developed digital lock-in amplifier and digital laser driving and controlling method, as well as wavelength modulation spectroscopy technology. Moreover, data acquisition and processing process were simplified effectively. Firstly, system scheme and designing details of optical and electrical modules were introduced in sequence according to the system principle and structure. Simulations of target gas absorption and interference from other gases have been analyzed. Broadening and overlap conditions of absorption lines under different pressures have also been described. Working pressure of the system was determined to be 200 Torr finally. Secondly, the minimum detection limit (MDL) was deduced <100 nmol . mol(-1) through performance test and analysis of one-circle spectrum scanning of ethane with 6 concentration levels (100 similar to 1 000 nmol . mol(-1)). The linear performance of this sensor was evaluated through similar to 10 min 2f peak value extraction test using aforementioned samples. The results indicated that the correlation was 0.999 65, and the relationship between gas concentration and the amplitude of 2f signal was clear. Finally, system noise was determined to be similar to 0.347 V by means of continuous 1 h test applied to nitrogen, thus the SNR and sensitivity were estimated to be similar to 28.56 and similar to 40 nmol . mol(-1), respectively. The new mid-infrared C2H6 sensor introduced in this paper not only realized nmol . mol(-1) level measurement but also greatly reduced the volume occupied by commercial instruments by use of digital driver and lock-in amplifier, which laid the foundation for realizing the goal of miniaturization and mobile measurement. In addition, for the applications with unlimited power consumption, sensor sensitivity can be further improved by using more powerful laser source or improving the performance of system modules such as lock-in and preamplifier, which can be applied in more fields.

Ultra-compact Organic Vertical-Cavity Laser with High-Contrast Grating Feedback for Gas Detection

Quasi-BIC laser enabled by high-contrast grating resonator for gas detection

Direction-Adjustable Single-Mode Lasing Via Self-Assembly 3D-Curved Microcavities for Gas Sensing.

Noise Canceled Graphene-Microcavity Fiber Laser Sensor for Ultrasensitive Gas Detection

An ultracompact refractive index gas-sensor based on photonic crystal microcavity

A Novel Compact and Selective Gas Sensing System Based on Microspherical Lasers

A Monolithic Graphene Functionalized Microlaser for Multispecies Gas Detection

External cavity quantum cascade laser based gas sensor for chemical detection

Controlled assembly of organic whispering-gallery-mode microlasers as highly sensitive chemical vapor sensors.

A Coin-Sized Oxygen Laser Sensor Based on Tunable Diode Laser Absorption Spectroscopy Combining a Toroidal Absorption Cell

Compact TDLAS Based Sensor Design Using Interband Cascade Lasers for Mid-Ir Trace Gas Sensing.

Intracavity Dynamics-Based Gain-Assisted Sensing with Microtubule Raman Microlaser

Integrated Plasmonic Biosensor on a Vertical Cavity Surface Emitting Laser Platform.

Recent Progress on Gas Sensor Based on Quantum Cascade Lasers and Hollow Fiber Waveguides

A near-infrared carbon dioxide sensor system using a compact folded optical structure for deep-sea natural gas hydrate exploration

Microfluidic channels incorporating organic distributed Bragg reflector lasers for in situ sensing applications

High-Q Silicon Microring Resonator with Ultrathin Sub-Wavelength Thicknesses for Sensitive Gas Sensing

High Sensitive Photoacoustic Gas Sensor Based on Low Output Power Laser and Digital Lock-in Technology

Mid-infrared photoacoustic gas monitoring driven by a gas-filled hollow-core fiber laser

Design of Detecting System for Multi-Component Gasesbased on Single Ultra-Narrow-linewidth Laser

A trace gas sensor using mid-infrared quantum cascaded laser at 4.8 microm to detect carbon monoxide]