Abstract:Purpose This study aims to research the time-varying mesh stiffness (TVMS) model for orthogonal face gear drives considering elastohydrodynamic lubrication (EHL) and provide a theoretical basis for understanding the dynamic characteristics of face gear drives. Design/methodology/approach Considering EHL, a novel model is proposed to calculate the TVMS of orthogonal face gears using the deformation compatibility condition. First, the tooth surface equations of orthogonal face gears are derived according to the tooth surface generation principle. Then, the oil film thickness on the tooth surface of face gears is obtained by solving the governing equations of EHL. Furthermore, the proposed model is used to calculate the TVMS of face gears along the mesh cycle and is verified. Finally, the effects of module, tooth number of shaper cutter and pressure angle on mesh stiffness are analyzed. Findings The results indicate that when the contact ratio is greater than 1 and less than or equal to 2, the TVMS of face gears exhibits a phenomenon of double-single tooth alternating meshing where sudden changes occur. As the module increases, the overall mesh stiffness of face gears increases, and the magnitude of the sudden change at the moment of single-double tooth alternating meshing gradually increases. As the tooth number of shaper cutter and pressure angle increase, so does the TVMS of face gears. When the effect of oil film is considered, the calculated TVMS of face gears slightly increases overall and the increase in average oil film thickness leads to a rise in the TVMS. This study provides a theoretical basis for understanding the dynamic characteristics of face gear drives. Originality/value This study's originality and value lie in its comprehensive approach, which includes conducting analysis based on loaded tooth contact, considering the influence of elastohydrodynamic lubrication, proposing a novel analytical–finite–element model, calculating TVMS of face gears, verifying the proposed model and analyzing the effects of typical structural parameters and oil film thickness.

An iterative model for mesh stiffness of spur gears considering slice coupling under elastohydrodynamic lubrication

A Global Iterative Model for Mesh Stiffness and Mesh Force Estimation of Flexible Internal Meshing in Spur Planetary Gear Sets

Effect of Shaft Misalignment on Time-varying Mesh Model of Spur Gear

A time‐varying meshing stiffness model for gears with mixed elastohydrodynamic lubrication based on load‐sharing

A mesh stiffness method using slice coupling for spur gear pairs with misalignment and lead crown relief

A novel time-varying mesh stiffness model for orthogonal face gear drives considering EHL

A Periodically Time-varying Mesh Stiffness Model for Spur Geared System Considering the Effect of Extended Tooth Contact

Novel Mathematical Modelling Methods of Comprehensive Mesh Stiffness for Spur and Helical Gears

Nonlinear mesh stiffness model using slice coupling for straight bevel gear considering axial mesh force component and extended tooth contact

Mesh stiffness and nonlinear dynamic response of a spur gear pair considering tribo-dynamic effect

A double-layer iterative analytical model for mesh stiffness and load distribution of early-stage cracked gear based on the slicing method

A novel analytical method for mesh stiffness calculation of helical gears with tooth profile modification

Spur gear time-varying mesh stiffness considering meshing phase difference caused by angle misalignment error

Three New Models for Evaluation of Standard Involute Spur Gear Mesh Stiffness

An improved analytical method for mesh stiffness calculation of spur gears with tip relief

Nonlinear dynamics of a spur gear pair with force-dependent mesh stiffness

Dynamic modeling of spur gear system considering the coupling effect between bearing deflection and gear mesh stiffness

Analytical calculation models for mesh stiffness and backlash of spur gears under temperature effects

Dynamic analysis of spur gears system with dynamic force increment and velocity-dependent mesh stiffness

Time-varying mesh stiffness model of a modified gear–rack drive with tooth friction and wear

Study on dynamic characteristics of spur gear transmission system based on different calculation models of time-varying mesh stiffness