Abstract:Combining collocated high-rate Global Navigation Satellite Systems (GNSS) and accelerometers produces broadband seismogeodetic displacements. However, accelerometer data must be heavily downweighted due to their baseline errors originating primarily in instrument rotations, and therefore their contribution to seismogeodetic displacements is seriously underestimated. We further introduced a gyroscope into this classic seismogeodesy to mitigate baseline errors and formulated advanced six-degree-of-freedom (6-DOF) seismogeodesy without undervaluing accelerometer data. A shake table holding one GNSS antenna, four accelerometers, and one gyroscope was used to simulate waveforms from the 2010 Mw 7.2 El Mayor-Cucapah earthquake. We found that the displacements derived from the 6-DOF seismogeodesy were up to 68% more accurate than those from the classic seismogeodesy over 0.04-0.4 Hz. Moreover, broadband rotations containing the permanent components were also generated, which were unachievable by integrating gyroscope data. We believe that the 6-DOF seismogeodesy is capable of improving both source rupture studies of large earthquakes and high-rise monitoring under strong seismic waves. Plain Lauguage Summary The faulting mechanism of large earthquakes has always been an enigma to the seismology community. One important reason is that we cannot measure accurately the low-frequency (e.g., <0.1 Hz) displacements at near-source stations using existing techniques. In particular, seismometer recovered low-frequency displacements are normally biased and incomplete due to intrinsic instrument limitations; Global Navigation Satellite Systems is able to obtain unbiased broadband (e.g., 0-5 Hz) displacements, but they are over 2 orders of magnitude noisier than seismometer measurements. We therefore develop an advanced technique that combines collocated Global Navigation Satellite System receivers, accelerometers, and gyroscopes to capture highly accurate earthquake-induced displacements and also rotations, spanning the frequencies from 0 to tens of hertz. We demonstrate that the accuracy of low-frequency displacements can be improved by up to 68% in contrast to traditional measuring techniques, and the permanent rotations can also be recovered, which can never be achieved by only inertial sensors (i.e., gyroscopes and accelerometers). We believe that this new technique can assist in deepening our understanding of the rupture process of large earthquakes, and the broadband rotations have the potential to unveil more unknowns about earthquake sources and Earth media beyond our present knowledge. We can get more prepared for future destructive earthquakes.

Recognition of Seismic Phases Recorded by High-Rate GNSS Measurements:Simulation and Case Studies

Capture of coseismic velocity waveform using GNSS raw Doppler and carrier phase data for enhancing shaking intensity estimation

Millimeter-level Ultra-Long Period Multiple Earth-circling Surface Waves Retrieved from Dense High-Rate GPS Network

High-rate Multi-Gnss Attitude Determination: Experiments, Comparisons with Inertial Measurement Units and Applications of GNSS Rotational Seismology to the 2011 Tohoku Mw9.0 Earthquake

Detecting Multiple Surface Waves Excited by the 2011 Tohoku‐Oki Earthquake from GEONET Observations

High-Rate Phase Association with Travel Time Neural Fields

Adaptive Denoising Approach for High-Rate GNSS Seismic Waveform Preservation: Application to the 2010 EI Mayor-Cucapah Earthquake and 2012 Brawley Seismic Swarm

Detection of Structural Vibration with High-Rate Precise Point Positioning: Case Study Results Based on 100 Hz Multi-GNSS Observables and Shake-Table Simulation

Studies on Auto-distinguishing Phase of Digital Seismic Recordings

Towards the Application of Seismogeodesy in Central Italy: a Case Study for the 2016 August 24 Mw 6.1 Italy Earthquake Modelling

Feature extraction and improved denoising method for nonlinear and nonstationary high-rate GNSS coseismic displacements applied to earthquake focal mechanism inversion of the El Mayor–Cucapah earthquake

Real‐time High‐rate Co‐seismic Displacement from Ambiguity‐fixed Precise Point Positioning: Application to Earthquake Early Warning

Experimental Study of Accuracy of High-Rate GNSS in Context of Structural Health Monitoring

Multi-GNSS high-rate RTK, PPP and novel direct phase observation processing method: application to precise dynamic displacement detection

High-rate Coseismic Displacements from Tightly Integrated Processing of Raw GPS and Accelerometer Data

High-Rate GPS Seismology Using Real-Time Precise Point Positioning With Ambiguity Resolution

GSeisRT: A Continental BDS/GNSS Point Positioning Engine for Wide-Area Seismic Monitoring in Real Time

Toward Fully Autonomous Seismic Networks: Backprojecting Deep Learning-Based Phase Time Functions for Earthquake Monitoring on Continuous Recordings

Can the phase of SNR oscillations in GNSS-IR be used to estimate sea-level height?

High-rate bridge displacement monitoring with low-rate virtual reference station data

Six-Degree-of-Boradband Seismogeodesy by Combining Collocated High-Rate GNSS, Accelerometers, and Gyroscopes