Abstract:Combining collocated high-rate Global Navigation Satellite Systems (GNSS) and accelerometers produces broadband seismogeodetic displacements. However, accelerometer data must be heavily downweighted due to their baseline errors originating primarily in instrument rotations, and therefore their contribution to seismogeodetic displacements is seriously underestimated. We further introduced a gyroscope into this classic seismogeodesy to mitigate baseline errors and formulated advanced six-degree-of-freedom (6-DOF) seismogeodesy without undervaluing accelerometer data. A shake table holding one GNSS antenna, four accelerometers, and one gyroscope was used to simulate waveforms from the 2010 Mw 7.2 El Mayor-Cucapah earthquake. We found that the displacements derived from the 6-DOF seismogeodesy were up to 68% more accurate than those from the classic seismogeodesy over 0.04-0.4 Hz. Moreover, broadband rotations containing the permanent components were also generated, which were unachievable by integrating gyroscope data. We believe that the 6-DOF seismogeodesy is capable of improving both source rupture studies of large earthquakes and high-rise monitoring under strong seismic waves. Plain Lauguage Summary The faulting mechanism of large earthquakes has always been an enigma to the seismology community. One important reason is that we cannot measure accurately the low-frequency (e.g., <0.1 Hz) displacements at near-source stations using existing techniques. In particular, seismometer recovered low-frequency displacements are normally biased and incomplete due to intrinsic instrument limitations; Global Navigation Satellite Systems is able to obtain unbiased broadband (e.g., 0-5 Hz) displacements, but they are over 2 orders of magnitude noisier than seismometer measurements. We therefore develop an advanced technique that combines collocated Global Navigation Satellite System receivers, accelerometers, and gyroscopes to capture highly accurate earthquake-induced displacements and also rotations, spanning the frequencies from 0 to tens of hertz. We demonstrate that the accuracy of low-frequency displacements can be improved by up to 68% in contrast to traditional measuring techniques, and the permanent rotations can also be recovered, which can never be achieved by only inertial sensors (i.e., gyroscopes and accelerometers). We believe that this new technique can assist in deepening our understanding of the rupture process of large earthquakes, and the broadband rotations have the potential to unveil more unknowns about earthquake sources and Earth media beyond our present knowledge. We can get more prepared for future destructive earthquakes.

Towards the Application of Seismogeodesy in Central Italy: a Case Study for the 2016 August 24 Mw 6.1 Italy Earthquake Modelling

Sequential Modelling of the 2016 Central Italy Earthquake Cluster Using Multisource Satellite Observations and Quantitative Assessment of Coulomb Stress Change

Coseismic Deformation and Triggered Landslides of the 2016 M-W 6.2 Amatrice Earthquake in Italy

Seismic effects at GPS stations: Case study of the 24 August 2016 Amatrice earthquake

Capture of coseismic velocity waveform using GNSS raw Doppler and carrier phase data for enhancing shaking intensity estimation

Comparative Analysis of Methods to Estimate Geodetic Strain Rates from GNSS Data in Italy

Post-Seismic Deformation Related to the 2016 Central Italy Seismic Sequence From GPS Displacement Time-Series

Six-Degree-of-Boradband Seismogeodesy by Combining Collocated High-Rate GNSS, Accelerometers, and Gyroscopes

Empirical evidence for multi-decadal transients affecting geodetic velocity fields and derived seismicity forecasts in Italy

High-rate Coseismic Displacements from Tightly Integrated Processing of Raw GPS and Accelerometer Data

Six-degree-of-freedom Seismogeodesy by Combining Collocated High-Rate GNSS, Accelerometers and Gyroscopes

Rupture Models of the 2016 Central Italy Earthquake Sequence from Joint Inversion of Strong-Motion and InSAR Datasets: Implications for Fault Behavior

Automatic Imaging of Earthquake Rupture Processes by Iterative Deconvolution and Stacking of High‐rate GPS and Strong Motion Seismograms

Feature extraction and improved denoising method for nonlinear and nonstationary high-rate GNSS coseismic displacements applied to earthquake focal mechanism inversion of the El Mayor–Cucapah earthquake

GNSS total variometric approach: first demonstration of a tool for real-time tsunami genesis estimation

Near-source ground motion estimation for assessing the seismic hazard of critical facilities in central Italy

Seismic Microzonation Mapping for Urban and Land Sustainable Planning in High Seismicity Areas (L'Aquila Municipality, Central Italy): The Contribution of 2D Modeling for the Evaluation of the Amplification Factors

Application of MEMS Data to Fast Inversion of Rupture Process: Tests with Recordings from the IRREEW Network

Real‐time Earthquake Early Warning with Deep Learning: Application to the 2016 M 6.0 Central Apennines, Italy Earthquake

On the Use of Instrumental and Macroseismic Data to Evaluate Ground-Motion Models: The 2019 Mw 6.4 Durres, Albania, Earthquake Sequence

Numerical simulation of the seismic response and soil–structure interaction for a monitored masonry school building damaged by the 2016 Central Italy earthquake