Abstract:Background: The ultrasonic transducer is one of the core components of ultrasound systems, and the transducer's sensitivity is significantly related the loss of electronic components such as the transmitter, receiver, and protection circuit. In an ultrasonic device, protection circuits are commonly used to isolate the electrical noise between an ultrasound transmitter and transducer and to minimize unwanted discharged pulses in order to protect the ultrasound receiver. However, the performance of the protection circuit and transceiver obviously degrade as the operating frequency or voltage increases. We therefore developed a crossed SMPS (Switching Mode Power Supply) MOSFET-based protection circuit in order to maximize the sensitivity of high frequency transducers in ultrasound systems.The high frequency pulse signals need to trigger the transducer, and high frequency pulse signals must be received by the transducer. We therefore selected the SMPS MOSFET, which is the main component of the protection circuit, to minimize the loss in high frequency operation. The crossed configuration of the protection circuit can drive balanced bipolar high voltage signals from the pulser and transfer the balanced low voltage echo signals from the transducer. Methods: The equivalent circuit models of the SMPS MOSFET-based protection circuit are shown in order to select the proper device components. The schematic diagram and operation mechanism of the protection circuit is provided to show how the protection circuit is constructed. The P-Spice circuit simulation was also performed in order to estimate the performance of the crossed MOSFET-based protection circuit. Results: We compared the performance of our crossed SMPS MOSFET-based protection circuit with a commercial diode-based protection circuit. At 60 MHz, our expander and limiter circuits have lower insertion loss than the commercial diode-based circuits. The pulse-echo test is typical method to evaluate the sensitivity of ultrasonic transducers. Therefore, we performed a pulse-echo test using a single element transducer in order to utilize the crossed SMPS MOSFET-based protection circuit in an ultrasound system. Conclusions: The SMPS-based protection circuit could be a viable alternative that provides better sensitivity, especially for high frequency ultrasound applications.

A Circuit for Transmiting/receiving Ultrasonic Pulse Based on the 80C196MC

Transmitting Circuit Design for Ultrasonic Transducer

A Design of PWM Driving Circuit for Ultrasonic Motor

Millimeter wave and sub-millimeter wave circuits for integrated system-on-a-chip

Transmitting and receiving circuit for two-channel high-frequency ultrasonic probe

The Design of Self-Oscillating Driving Circuit for a Plagiodont Ultrasonic Motor

Design on Driving System of Hybrid Transducer Type Ultrasonic Motor Based on DSP

Development of Integrated Preamplifier for High-Frequency Ultrasonic Transducers and Low-Power Handheld Receiver

Design of Intelligent Ultrasonic Power Source Based on FPGA

Design and fabrication of a monolithic optoelectronic integrated circuit chip based on CMOS compatible technology

Design and Implementation of A Novel Drive for the Ultrasonic Motor

Development of the High Frequency Pulse Electrical Source

Integrated Transceivers for Emerging Medical Ultrasound Imaging Devices: A Review

Design on the experiment device of ultrasonic telemeter digital circuit

Design and Implementation of Driving Control Circuit of a SAW Electronic Cigarette Atomization Chip

Crossed SMPS MOSFET-based protection circuit for high frequency ultrasound transceivers and transducers

Design, Implementation And Analysis Of Solid-State Megahertz Continuous High-Repetition-Frequency High-Voltage Pulse Source

Refined control circuit for high-speed pulse' level

A Supply-Doubled 3-Level Pulse-Shaping Pulser for Ultraso Medical Imaging Applications

A Novel Half-Bridge Drive Circuit For Ultrasonic Motor Based On Fpga

Design of Integrated High Voltage Pulse Generator for Medical Ultrasound Transmitters