Abstract:Abstract Subject to this study is the modification of an experimental two-component polyurethane (2C PUR) as an alternative adhesive for structural hardwood bonding. The 2C PUR has been adapted by calcium carbonate as filler to increase its modulus of elasticity with the aim of increasing the modulus analogue to the ones typically observed for classic amino- and phenol based adhesives. The 2C PUR system was compared with a commercial one-component polyurethane (1C PUR) and a phenol resorcinol formaldehyde (PRF) adhesive. The wetting properties of the adhesives were tested in terms of surface tension, polar and dispersive part and contact angle on European beech wood ( Fagus sylvatica L.). In addition, adhesive polymer films of 2C PUR were tested for tensile strength and modulus of elasticity (E-Modulus) following ISO 527-1. The adhesives bond performance on beech wood was determined by lap-joints according to EN 302-1 in various climate conditions. The results show that 2C PUR has proper wettability properties on beech wood. Adding 60% wt filler to the polyol component increased the E-Modulus from 2.3 GPa (0%) to 4.4 GPa. The tensile strength of the modified 2C PUR polymer films was comparable with the industrial 1C PUR. Tensile shear strength and wood failure percentage of 2C PUR lap-joints were increased by adding filler and met requirements in dry and re-dried conditions according to EN 302-1. However, the addition of filler didn’t result in an improvement in wet conditions. The present study shows sufficient performance for bonding hardwood with 2C PUR in dry conditions, while the system still needs to be improvement regarding its performance in humid conditions.

Study of Two- Component Reactive Polyurethane Building Sealing Materials

Synthesis and Study of Novel UV-Curable Powder Coatings

Synthesis and properties of elastomeric polyurethane for grouting

Interactions Between Organic and Inorganic Phases in PA- and PU/PA-Modified-Cement-Based Materials

Study on contamination–free and transparent two–component PU adhesive

Studies on the influence of soft-segment structure on the properties of polyurethane adhesive

Study in Curing Properties of Two-Component Solvent-Free Polyurethane Adhesive

Synthesis and Kinetics of Polyurethane-Acrylate Oligomer

The Synthesis and Properties of Silylated Polyurethane-Urea Based on HTPB Sealant

Synthesis of Reactive Polyurethane Adhesives and Studying the Effect of Ketonic Resins

Study on Preparation and Performance of Reactive Polyurethane Hot Melt Adhesives Based on a Polycarbonate Diol and a Polyester Diol

Study on UV Curable Aqueous Polyurethane Coatings

Preparation and Properties of High Solid Content and Low Viscosity Waterborne Polyurethane—Acrylate Emulsion with a Reactive Emulsifier

Synthesis of Polyurethane Acrylate and Application to Ultraviolet-Curable Pressure-Sensitive Adhesive

Synthesis of polyurethane acrylate and application to UV-curable pressure-sensitive adhesive

Synthesis and properties of self-crosslinkable polyurethane-urea with silsesquioxane formation

Preparation and Properties of Two-Component and Double-Crosslinking Waterborne Polyurethane-Acrylic Dispersions

Preparation of UV-curable strippable coatings based on polyurethane acrylate from CO2-polyol and different isocyanates

Study on the Pyrolytic Behaviors and Kinetics of Rigid Polyurethane Foams

Modifying elastic modulus of two-component polyurethane adhesive for structural hardwood bonding

Synthesis and properties of polyurethane acrylate oligomer based on polycaprolactone diol