Abstract:The MAX phase has attracted much attention due to its unique properties combined with the merits of both metal and ceramic, including the low density, high electrical conductivity and good oxidation resistance, which makes it significant for possible applications in various high temperature or other environments. There is a lot of research work on Ti2AlX (X=C, N). However little research about thermodynamic properties at high pressure is carried out. So we study the structural, mechanical and thermodynamic properties of Ti2AlC and Ti2AlN at various pressures and temperatures. The first-principles calculations based on electronic density-functional theory framework are used to investigate the properties at various pressures. The cut-off energy is 350 eV. Converged results are achieved with 10102 special K-point meshes. The self-consistent convergence of total energy is set to be 5.010-6 eV/atom. According to the calculated structural parameters at various pressures, we can find that the ratios V/V0 (V0 denotes the system volume at 0 GPa) of Ti2AlX are reduced by 20.59% and 18.93%, respectively, so the compressibility of the system is strong. As the internal pressure increases, the curves of V/V0 become gentle. Then we calculate elastic constants at pressures ranging from 0 to 50 GPa in steps of 10 GPa. It is obvious that the Ti2AlX is mechanically stable because all of the elastic constants satisfy the Born stability criteria. The bulk modulus, shear modulus and Young's modulus linearly increase with internal pressure increasing, implying that the pressure can improve the resistance to volume deformation. The ductility and brittleness can be judged according to Pugh's criterion (ratio of bulk modulus to shear modulus B/G), and the brittle nature turns into ductile nature in a pressure range of 40-50 GPa for the Ti2AlX since the value of B/G exceeds 1.75. Finally, we study the thermodynamic properties at various pressures and temperatures based on the quasi-harmonic Debye approximation theory, including the bulk modulus, heat capacity and thermal expansion coefficient. The bulk modulus decreases with temperature increasing but increases with pressure increasing. The heat capacity at constant volume Cv and the heat capacity at constant pressure Cp have the same variation tendency, while Cv obeys the Dulong-Petit limit. It is easy to see that temperature and pressure have opposite influences on heat capacity and the effect of temperature is more significant than that of pressure. The effects of temperature and pressure on linear expansion coefficient mainly occur at low temperature and the effect of pressure is not so considerable when the pressure exceeds 30 GPa. Above all, the effects of temperature and pressure on thermodynamic properties are inverse.

Ultrasonic Measurement and Isothermal Equation of State for LY12Al under Static Pressures

Isothermal Equation of State of Aluminium

The first-principles calculations for the elastic properties of Zr2Al under compression

Theoretical Investigation of the High Pressure Structure, Lattice Dynamics, Phase Transition, and Thermal Equation of State of Titanium Metal

Ab initio calculations of elastic constants and thermodynamic properties of Li2O for high temperatures and pressures

Ab Initio Calculation of Lattice Dynamics and Thermodynamic Properties of Beryllium

Equation of State for Aluminum at High Pressures

The Velocity, Refractive Index, and Equation of State of Liquid Ammonia at High Temperatures and High Pressures.

Structural, Mechanical, and Thermodynamic Properties of Ti2AlX (X = C, N) at High Pressure

Experimental and Theoretical Studies on the Elasticity of Molybdenum to 12 GPa

Thermoelastic Equation Of State Of Molybdenum

First-principles Investigation of the Structural, Mechanical and Thermodynamic Properties of Al2Cu Phase under Various Pressure and Temperature Conditions

Anisotropy in Elasticity and Physical Properties of Ti2B under High Pressure

Ab initio study of structural, electronic and thermodynamic properties of Be<sub>12</sub>V under high temperature

Pressure-induced effects on the mechanical and thermophysical properties of LiAl2X (X = Rh, Pd, Ir and Pt) ternary intermetallic compounds

Elasticity, mechanical and thermal properties of submicron h-AlN: in-situ high pressure ultrasonic study

Pressure Effects on Elastic and Thermodynamic Properties of Zr3al Intermetallic Compound

Ab-initio Study of Phase Stability, Elastic and Thermodynamic Properties of AlY Alloy under Pressure

Thermal Equation of State and Thermodynamic Grüneisen Parameter of Beryllium Metal

An improved multiphase equation of state for aluminum in hypervelocity impact

Equation of State and Electrical Transport Properties of Mixture of Li1.2Mn0.54Co0.13Ni0.13O2 and LiNi0.87Co0.09Mn0.03Al0.01O2 at High Pressure