Simulation of the Effect of Noise Measurement Time-points on Error of 8-Hour Equivalent Continuous Sound Level Estimation

Yue Zhao
2008-01-01
Abstract:Objective To study the effect of noise measurement time-points in a shift on estimation accuracy for A-weighted 8-hour equivalent continuous sound level(LAeq·8 h).Methods A-weighted noise levels in 59 work shifts in a textile mill,including 25 weaving shifts and 34 maintenance shifts were measured using SH126 personal noise dosimeter.During the measurement in each shift,LAeq for every 10 minutes(LAeq·10 min)were saved in the dosimeter all together 48 LAeq·10 mins were recorded in one shift.In order to simulate routine approach of LAeq estimation based on short-time noise measurement at fixed time-points,a block-randomized sampling procedure was developed to randomly select 1,2,3,4,5,6,7 and 8 LAeq·10 min(s)from each of 59 measured noise data in 8 sampling procedure respectively.Based on sampled LAeq·10 min(s)in each sampling,8 estimated LAeq·8 h(s)were calculated for each of 59 shifts.These estimated LAeq·8 h were compared with corresponding actual LAeq·8 h calculated from all 48 LAeq·10 min respectively.The absolute values of differences in-between them were calculated to reflect the estimation error,which was used to evaluate the effect of measurement time-points increase on estimation error of LAeq.Results The pattern of noise exposure in weavers and maintenance workers in a shift was distinctively different.The former exposed to typical steady noise,while the latter exposed to intermittent unsteady noise.When the measurement time-point was set to 1,the estimation error for weavers was(1.00 ± 1.33)dB,and for maintenance workers was(8.62 ± 11.90)dB.For both weavers and maintenance workers,the estimation errors decreased as the measurement time-points increased.When the measurement time-points reached to 3~4,the figure of estimation error became flat gradually.However,when the measurement time-points were equal,the estimation errors for maintenance shifts were always higher than those of weaving shifts.Conclusions When estimating the unsteady noise exposure,the measurement result based on the single time-point would cause bigger error.To increase the measurement time-points may diminish the estimation error.As to the steady noise exposure,the significance of diminishing the estimation error by increasing the measurement time-points is rather small.
What problem does this paper attempt to address?