Abstract:Using sodium bisulfite aqueous solution as extractant, the reactive extraction experiments for a heptaldehyde-undecane mixture were carried out. The results show that when the molar ratio between sodium bisulfite and heptaldehyde, the stirring speed, the volume fraction of aqueous phase or the temperature increase, the reactive extraction rate increases. In contrast, larger molar ratio between sodium bisulfite and heptaldehyde, smaller volume fraction of aqueous phase or lower temperature leads to higher equilibrium conversion of heptaldehyde. According to the mass transfer coefficients of the reactive extraction system and the rate constants obtained from the study of intrinsic kinetics, the Ha numbers were estimated. The results show that under the conditions in this paper, 0.3 < Ha < 3, the reactive extraction process was mainly a mixing control process. Since heptaldehyde is soluble in water while sodium bisulfite is not soluble in undecane, the reaction occurs within the film and the main body of the aqueous phase. For the reactive extraction of 1.0 wt % heptaldehyde in undecane using aqueous sodium bisulfite as the extractant, three methods of performing three-stage reactive extraction were investigated. The results showed that equilibrium extraction is highly necessary to ensure the extraction efficiency. Cross-current equilibrium extraction is suitable for situations where high product purity is required; for situations where the separation requirements are not too high, counter-current equilibrium extraction should be preferred.

Refining of Crude Methyl Benzoate

The Study of Refining Solanesol by Molecular Distillation

Crude Benzol Coking Products and Development of Its Hydro-Refining Technology

Gas Phase In-Situ Hydrogenation of Methyl Benzoate to Benzaldehyde

Synthesis of 1-Chloro-2,5-dimethoxybenzene

Improvement on Synthesis and Purification Process of Neopentyl Glycol

Novel Economical Route for Synthesis of 2, 4-Dimethoxybenzaledhyde

Hybrid process of distillation side-connected with pervaporation for separation of methanol/MTBE/C4 mixture

Efficient Conversion of Methane to Aromatics in the Presence of Methanol at Low Temperature

Preparation of 5,6-Dichloro-2-methylbenzimidazole

Study on synthesis of benzyl p-hydroxybenzoate by phase transfer catalysis

Coked crude benzene refining method

Study on Segregation Process and Equilibrium Distribution Coefficients of Impurities during Zone Refining of Bibenzyl

Enantioseparation of Benazepril Intermediates by High‐Performance Liquid Chromatography on Chiral CDMPC Column

Crude benzene hydrofining method

Hydrolysis of Methyl Acetate and Methanol Mixture in a Catalytic Distillation Column

Iron-chloride Ionic Liquid Immobilized on SBA-15 for Solvent-Free Oxidation of Benzyl Alcohol to Benzaldehyde with H2O2

Ethylene Glycol Purification by Melt Crystallization: Removal of Short-Chain Glycol Impurities

Study on the Reactive Extraction Process for Heptaldehyde–Undecane–Sodium Bisulfite Aqueous Solution System

EXPERIMENTAL STUDY ON DESULFURIZATION OF MTBE BY ALKALI WASHING AND EXTRACTIVE DISTILLATION

PURIFICATION OF METHYLTRICHLOROSILANE