Abstract:Thin-walled structures are now widely used in aerospace structural components, turbines and many other applications, while the control of machining distortion has become one of the most difficult problems influencing their machining quality. Machining distortion is the result of many factors, among which the machining induced residual stress is an important issue. In this paper, a finite element analysis (FEA) approach of predicting machining induced residual stresses and the consequent distortion is presented, which includes the simulation of machining process, processing of the extracted residual stress data, loading of the fitted stress data and distortion analysis. Professional metal cutting simulation and optimization software, TWS AdvantEdge, was used for 3D machining process simulation. The constitutive model of work piece material was obtained from pressure bar tests and orthogonal cutting tests, and has been proved of good accuracy. General FEM software ABAQUS was used to create and mesh the thin-plate work piece. The meshing data outputted from ABAQUS and stress data calculated by AdvantEdge were processed with MATLAB, obtaining the stress distribution of each element, and then the stress distribution was input back into ABAQUS to calculate the distortion. Experiments were carried out, measuring the residual stress and distortion, to verify the FEM simulation. Under the designed simulation and experiment conditions, the machining induced residual stresses in feeding and peripheral directions are both tensile at the machined surface and fall off to a maximum compressive state with the increase in depth, after which the compressive stresses decrease and approach a steady value next to zero in near work piece substrate. Both experimental and FEA simulation results show that the release of the residual stresses make the thin plate to become convex. Yet there are still differences in conditions between simulation and experiment, and further will be carried out- to improve the accuracy.

Finite Element Simulation and Experimental Research of Residual Stresses in the Cutting Based on the Coupled Thermo-mechanical Model

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

Numerical Simulation Study on Milling Force for Aerospace Aluminum Alloy

Finite Element Method Simulation for Residual Stress in Quenched Aluminum Alloy Thick-Plate and Its Effect on Machining Distortion

Three-dimensional numerical simulation for high speed milling of aerospace aluminum alloy

3D Finite Element Simulation and Experiment of Residual Stress on the Cutting Surface

Numerical simulation on surface residual stress for titanium alloy

Constitutive Model of Aviation Aluminum-Alloy Material in Metal Machining

Coupled Thermo-mechanical Model for Metal Orthogonal Cutting Process and Finite Element Simulation

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

Finite Element Simulation of Residual Stress on the Surface in the Cutting Considering Tool Flank Wear

3D Coupled Thermo-Mechanical Simulation of Surface Roughness and Residual Stress in End Milling Aluminum Alloy

Study on Residual Stress Produced in Milling of Aeronautic Structure

Machining mechanism and stress model in cutting Ti6Al4V

Three Dimensional Finite Element Simulation and Analysis of Residual Stress in Milling

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Numerical investigations on residual stresses in orthogonal cutting of Ti-6A1-4V

Analysis and Simulation of Machining Deformation Resulting from Residual Stress

Finite element analysis of residual stresses and thin plate distortion after face milling

Simulation Study of Cutting-Induced Residual Stress