Abstract:Transformation into electric or photoelectric functional composite from non-conjugated polymers is a great challenge due to the presence of a large number of locative states. In this paper, carbon nanofiber was synthesized via hydrothermal carbonization utilizing carboxymethyl cellulose as a precursor, and the carbon nanofiber/Cu nanocomposite was constructed for defect passivation. The results indicated that the resulting nanocomposites exhibited good absorbance in visible light range and NIR (near-infrared). The photoconductive responses to typical weak visible light (650 nm et al.) and NIR (808, 980, and 1064 nm) were studied based on Au gap electrodes on flexible polymer substrates. The results exhibited that the nanocomposite’s solid thick film showed photocurrent-switching behaviors to visible light and NIR, the switch-ratio was depending on the wavelengths and power of incident lights. The positive and negative photoconductance responses phenomenon was observed in different compositions and changing excited wavelengths. Their photophysical mechanisms were discussed. This illustrated that the nanocomposites easily produce free electrons and holes via low power of incident light. Free electrons and holes could be utilized for different purposes in multi-disciplinary fields. It would be a potential application in broadband flexible photodetectors, artificial vision, simulating retina, and bio-imaging from visible light to NIR. This is a low-cost and green approach to obtain nanocomposite exhibiting good photocurrent response from the visible range to NIR.

Inside Cover: an Integrated “energy Wire” for Both Photoelectric Conversion and Energy Storage (angew. Chem. Int. Ed. 48/2012)

An Integrated “energy Wire” for Both Photoelectric Conversion and Energy Storage

Innentitelbild: An Integrated “Energy Wire” for both Photoelectric Conversion and Energy Storage (Angew. Chem. 48/2012)

A Novel “energy Fiber” by Coaxially Integrating Dye-Sensitized Solar Cell and Electrochemical Capacitor

An Integrated Device For Both Photoelectric Conversion And Energy Storage Based On Free-Standing And Aligned Carbon Nanotube Film

A Twisted Wire‐Shaped Dual‐Function Energy Device for Photoelectric Conversion and Electrochemical Storage

Polymer-Derived Carbon Nanofiber and Its Photocurrent-Switching Responses of Carbon Nanofiber/Cu Nanocomposite in Wide Ranges of Excited Light Wavelength

Fully solar-powered photoelectrochemical conversion for simultaneous energy storage and chemical sensing.

Designing aligned inorganic nanotubes at the electrode interface: towards highly efficient photovoltaic wires.

Integrated Devices to Realize Energy Conversion and Storage Simultaneously

Inside Back Cover: Carbon Nanotubes Bridged with Graphene Nanoribbons and Their Use in High‐Efficiency Dye‐Sensitized Solar Cells (angew. Chem. Int. Ed. 14/2013)

Energy Fibers: Self‐Powered Energy Fiber: Energy Conversion in the Sheath and Storage in the Core (adv. Mater. 41/2014)

All Carbon Nanotube Fiber Electrode-Based Dye-Sensitized Photovoltaic Wire

Integrated power fiber for energy conversion and storage

Efficient Dye-Sensitized Photovoltaic Wires Based On An Organic Redox Electrolyte

Intertwined Aligned Carbon Nanotube Fiber Based Dye-Sensitized Solar Cells

Polymer photovoltaic wires based on aligned carbon nanotube fibers

In-Situ Fabricated Transparent Flexible Nanowire Device with Wavelength-Regulated Dual-Function of Photodetector and Photonic Synapse

Self-powered Energy Fiber: Energy Conversion in the Sheath and Storage in the Core.

Integrated Polymer Solar Cell and Electrochemical Supercapacitor in a Flexible and Stable Fiber Format

Dye-Sensitized Solar Cells with Vertically Aligned Tio2 Nanowire Arrays Grown on Carbon Fibers