Abstract:As the third generation solar cell,dye-sensitized solar cells (DSSCs) have attracted tremendous amount of interest in scientific research and industrial applications during the past 25 years because of their simple production procedures,low-cost,environmental friendliness of raw materials,and relatively high power conversion efficiency (PCE).As an important component,counter electrode (CE) not only transfers electrons flowing from the external circuit to the electrolyte,but also catalyzes the reduction of oxidized electrolyte at the CE/electrolyte interface.So far,Pt as a noble metal has been the most commonly used CE for laboratory research due to its excellent electrocatalytic activity,high conductivity and good chemical stability.Unfortunately,the high cost and low abundance ratio of Pt create a big obstacle for large-scale applications of DSSCs.Therefore,exploiting Pt-free CE materials with high electrocatalytic activity and low cost is vital for the practical applications.Recently,a lot of Pt-free materials,such as graphene,carbon,conductive polymers and metal compounds (including carbide,oxide,sulfide,nitride and selenide),have been proposed for use as the CE of DSSCs.Among those materials,metal selenides have drawn great interest due to their distinctive electronic structures,interesting chemical behaviors and distinctive physical properties.The electrocatalytic activity of a substance not only depends on the chemical composition but also relies on the morphology of materials.While the investigation on developing new electrocatalysts has been extensively conducted,the morphology effect on the electrocatalytic activity has rarely been studied.In this paper,a simple low temperature hydrothermal method was used to synthesize NiSe2 with nanorod (r-NiSe2) and nanoparticle (p-NiSe2) morphologies.A drop-cast method was used to fabricate CE films without any post-treatment.Since the only difference for those two CEs used in DSSC is their morphology,it allows us to study the morphology effect on the electrocatalytic activity and solar cell performances.By changing the drop-cast times,the loading amount from 5.0 to 80.0 μg/cm2 could be controlled.The PCE of DSSCs increases with increasing the loading amount up to 10 μg/cm2 and then decreases with further increasing the loading amount of NiSe2.Thus,the best loading amount has been determined to be 10 μg/cm2.All the measurements in this paper are based on the best loading amount.The DSSC with r-NiSe2 CE achieves PCE of 8.52％,which is higher than that for the p-NiSe2 based DSSC (8.13％) and even better than the Pt based DSSC (8.20％) at comparable conditions.This indicates that NiSe2 nanorod is better than NiSe2 nanoparticle as the CE of DSSCs towards higher photovoltaic performance.To elucidate the catalytic activity of r-NiSe2 and p-NiSe2,electrochemical impedance spectroscopy,Tafel polarization curve and cyclic voltammetry were conducted.The experimental results indicate that the r-NiSe2 CE exhibits higher electrocatalytic activity than p-NiSe2 CE,which explains the reason that the DSSC based on r-NiSe2 CE has the higher PCE than the p-NiSe2 CE.The result implies that by varying the morphologies of CE materials could also fulfill the improvement of solar cell's performance.

Hierarchical NiSe microspheres as high-efficiency counter electrode catalysts for triiodide reduction reaction

Oleic Acid-Mediated Synthesis of Small-Sized and Monodisperse NiSe2 Nanowires As Counter Electrode Catalysts for Triiodide Reduction

Morphology Effect of NiSe Hierarchical Microspheres on the Performance of Dye-Sensitized Solar Cells

Surface active-site engineering in NiCoSe2/nitrogen-doped carbon dodecahedrons for efficient triiodide reduction in photovoltaics

Enhancement of the triiodide reduction reaction by doping molybdenum in NiSe hierarchical microspheres: a theoretical and experimental study

Boosting Catalytic Performance of Hierarchical Co/Co0.85Se Microspheres Via Mott-Schottky Effect Toward Triiodide Reduction and Alkaline Hydrogen Evolution

3D hierarchical FeSe 2 microspheres: Controlled synthesis and applications in dye-sensitized solar cells

Iron-doping and Facet Engineering of NiSe Octahedron for Synergistically Enhanced Triiodide Reduction Activity in Photovoltaics.

Size-controllable Synthesis of NiCoSe2 Microspheres As a Counter Electrode for Dye-Sensitized Solar Cells

Size-dependent Activity of FeSe2 Nanosheets for Efficient Tri-Iodide Reduction Reaction in Photovoltaics

Size-dependent activity of FeSe 2 nanosheets for efficient tri-iodide reduction reaction in photovoltaics

In Situ Growth of Hierarchical Nis2 Hollow Microspheres As Efficient Counter Electrode for Dye-Sensitized Solar Cell

Synthesis of Nise2/Reduced Graphene Oxide Crystalline Materials and Their Efficient Electrocatalytic Activity in Dye-Sensitized Solar Cells

Prussian blue-derived synthesis of uniform nanoflakes-assembled NiS2 hierarchical microspheres as highly efficient electrocatalysts in dye-sensitized solar cells

One-Pot Solvothermal in Situ Growth of 1D Single-Crystalline NiSe on Ni Foil As Efficient and Stable Transparent Conductive Oxide Free Counter Electrodes for Dye-Sensitized Solar Cells.

Development of binary transition metallic selenide (NiSe/Co3Se4) hybrid counter electrode for highly efficient Pt-free dye-sensitized solar cells

Highly Efficient Dye-Sensitized Solar Cells with NiSe2 Counter Electrodes: Effect of Morphology on the Electrocatalytic Activity and the Photovoltaic Performance

Selenium-induced NiSe 2 @CuSe 2 hierarchical heterostructure for efficient oxygen evolution reaction

Electronic band structure adjustable NiSxSe1-x ternary catalysts show omnipotent boosting ability in photoelectrochemistry, electrocatalysis and photocatalysis

Hierarchical Iron-Doped Nickel Diselenide Hollow Spheres for Efficient Oxygen Evolution Electrocatalysis

Few-Layer MoSe2 Possessing High Catalytic Activity Towards Iodide/Tri-iodide Redox Shuttles