Abstract:The elastic properties of 1D nanostructures such as nanowires are often measured experimentally through actuation of the nanowire at its resonance frequency, and then relating the resonance frequency to the elastic stiffness using elementary beam theory. In the present work, we utilize large scale molecular dynamics simulations to report a novel beat phenomenon in [110] oriented Ag nanowires. The beat phenomenon is found to arise from the asymmetry of the lattice spacing in the orthogonal elementary directions of the [110] nanowire,i.e., [-110] and [001] directions, which results in two different principal moments of inertia. Because of this, actuations imposed along any other direction are found to decompose into two orthogonal vibrational components based on the actuation angle relative to these two elementary directions, with this phenomenon being generalizable to <110> FCC nanowires of different materials (Cu, Au, Ni, Pd and Pt).The beat phenomenon is explained using a discrete moment of inertia model based on the hard sphere assumption, the model is utilized to show that surface effects enhance the beat phenomenon, while the effect is reduced with increasing nanowires cross-sectional size or aspect ratio.Most importantly, due to the existence of the beat phenomena, we demonstrate that in resonance experiments only a single frequency component is expected to be observed, particularly when the damping ratio is relatively large or very small.Furthermore, for a large range of actuation angles, the lower frequency is more likely to be detected than the higher one,which implies the experimental predictions of Young's modulus obtained from resonance may in fact be under predictions. The present study therefore has significant implications for experimental interpretations of Young's modulus as obtained via resonance testing.

Dynamic Nanomechanics of Zinc Oxide Nanowires

In Situ Mechanical Resonance Behaviour of Pristine and Defective Zinc Blende GaAs Nanowires

Beat Phenomena in Metal Nanowires, and Their Implications for Resonance-Based Elastic Property Measurements.

Electrical Actuation and Readout in a Nanoelectromechanical Resonator Based on a Laterally Suspended Zinc Oxide Nanowire

Molecular Dynamics Simulation of the Elastic Properties of Metal Nanowires in a Transverse Electric Field

Tuning the Resonance Properties of 2D Carbon Nanotube Networks Towards a Mechanical Resonator

Dynamic fatigue studies of ZnO nanowires by in-situ transmission electron microscopy

In Situ Mechanical Properties of Individual Zno Nanowires and the Mass Measurement of Nanoparticles

In Situ Transmission Electron Microscopy Investigation on Fatigue Behavior of Single ZnO Wires under High-Cycle Strain

Modeling and Experimental Study of Nanoelectromechanical Oscillator Using Single Zinc Oxide Nanowire

The nano-mechanical property of the single ZnO nanowire by scanning electron microscope nano-probe system

Determination of the Natural Frequency of a Cantilevered ZnO Nanowire Resonantly Excited by a Sinusoidal Electric Field

Zinc oxide nanowire electromechanical oscillator

Piezoelectric Characterization of a Single Zinc Oxide Nanowire Using a Nanoelectromechanical Oscillator

Size-dependent Young's modulus in ZnO nanowires with strong surface atomic bonds.

Mechanical/Electrical Characterization of ZnO Nanomaterial Based on AFM/Nanomanipulator Embedded in SEM

The Piezotronic Effect of Zinc Oxide Nanowires Studied by in Situ TEM

AFM Investigation of Nanomechanical Properties of ZnO Nanowires

Dynamic in situ field emission of a nanotube at electromechanical resonance

Automated Electrical Measurements of Single ZnO Nanowire with Cu and Au Electrodes Under Axial Strain

Surface Elasticity Effect on the Dynamic Behavior of a Nanowire-Loaded Resonator.