Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Experimental Study of Flow and Heat Transfer in Heat Exchanger with Small Channels

Experimental Study on Flow and Heat Transfer Characteristics in Rectangular Microchannel

Experimental Study on Heat Transfer Characteristics of Two-Phase Flow in Square and Rectangular Channels

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Investigation Of Flow And Heat Transfer Characteristics In Rectangular Small/Microchannels

Experimental and Numerical Studies of Fluid Flow Confined in Microchannel

Single-phase flow and heat transfer in micro-channels

Experimental Study on Heat Transfer and Flow Resistance Performance of a Microchannel Heat Exchanger with Zigzag Flow Channels

Fluid Flow And Heat Transfer Characteristics In Rectangular Microchannels

Experiments of Condensation Heat Transfer in Micro Channel Heat Exchanger

Thermal Performance of Crossflow Microchannel Heat Exchangers

Thermal–hydraulic Performance of Small Scale Micro-Channel and Porous-Media Heat-Exchangers

Numerical Investigation on Flow Boiling Heat Transfer in Elliptic Microchannel Heat Exchanger with Micro Fins

Single-phase Flow and Heat Transfer in Swirl Microchannels

Experimental Study on Heat Transfer and Pressure Drop Characteristics in a Microchannel Heat Exchanger Assembly with S-shaped Fins

Experimental Study of Single-Phase Flow and Heat Transfer in Rectangular Channels under Uniform and Non-Uniform Heating

Numerical investigation of heat transfer and fluid flow characteristics inside a wavy channel

NUMERICAL STUDY ON FLOW AND HEAT TRANSFER PERFORMANCE OF A NOVEL MULTILAYER MINI-CHANNEL HEAT EXCHANGER WITH LOW AXIAL HEAT CONDUCTION

Experimental Study on Flow and Heat Transfer in Circular Small-scale Channels for Aeroengines

Experimental Study and Analysis About Flow and Heat Transfer in Micro-tubes

Experimental and Theoretical Analysis for Heat Transfer and Flow Performance of Mini-channel Parallel Flow Heat Exchanger in Vehicle