Abstract:Thermoelectric (TE) materials capable of directly converting heat into electricity have become a highly potential category in energy materials and are expected to tackle the energy issue of the future. Among a variety of TE materials, lead telluride (PbTe) has been recognized as an outstanding mid-temperature TE material with an applicable TE figure of merit (ZT) of ~1.2. However, due to the toxicity of both Pb and Te, development of alternative mid-temperature TE materials is urgently required. Bismuth sulﬁde (Bi2S3) is specially selected in the present study as the most promising candidate for alternating PbTe mainly because of its potentially high Seebeck coefficient (102−103 μVK-1). Unfortunately, the generally poor electrical conductivity (<102 S/cm) and the resulting low ZT (~0.2) of Bi2S3 severely restrict its applicability. In this work, by controlling the substrate temperature, the volatility of sulfur would lead the compositional deviation from the chemical stoichiometry of Bi2S3 and the electrical conductivity of the sulfur-vacancy introduced Bi2S3-x would thus be improved. Similarly, BiCl3 was also considered and applied as a donor dopant to improve the electrical conductivity. Furthermore, a series of novel BiCl3 doped Bi2S3-Cu nanoparticles layer-by-layer composite films were designed and fabricated through the newly built dual-beam pulsed laser deposition for improving the electric conductivity without seriously sacrificing the Seebeck coefficient. The prepared highly crystalline intrinsic Bi2S3 films on insulated SiO2/Si substrates exhibit a very high electric conductivity of 638 Scm-1 evidently due to the simultaneously enhanced carrier concentration and mobility, and the Seebeck coefficient of - 453 μVK-1. The resulting power factor is 137 μWcm-1K-1 which is four times higher than the reported highest value (29 μWcm-1K-1) from the chemically prepared Bi2S3 so far. The introduction of BiCl3 into Bi2S3 indeed leads to an enhancement of the electrical conductivity from 170 Scm-1 (before BiCl3 doping) to 450 Scm-1 whereas the Seebeck coefficient decreases from -522 μVK-1 to -221 μVK-1. On the sake of enhancing the electricity conductivity and Seebeck coefficient simultaneously, the Cu nanoparticles were introduced into the BiCl3 doped Bi2S3 film. The heterostructure of Cl doped Bi2S3/Cu played an important role in obtaining the high electrical conductivity of 715 Scm-1, Seebeck coefficient of -413 μVK-1 and the power factor of 122 μWcm-1K-1 which is twice higher than those of the intrinsic Bi2S3 film (49 μWcm-1K-1).

Thermoelectric Properties of CoSb<sub>3</sub> Nanoparticle Films

Facile Synthesis of Monodisperse Cu3SbSe4 Nanoparticles and Thermoelectric Performance of Cu3SbSe4 Nanoparticle-Based Materials

CoSb 3 -Based Thin-Film Thermoelectric Devices with High Performance Via Electrode Optimization

Thermoelectric Properties of P-Type Cosb3 Nanocomposites with Dispersed Cosb3 Nanoparticles

Rational band engineering and structural manipulations inducing high thermoelectric performance in n-type CoSb3 thin films

Enhanced power factor and suppressed lattice thermal conductivity of CoSb3 Skutterudite by Ni substitution and nanostructuring for high thermoelectric performance

Improved Thermoelectric Figure of Merit in N-Type CoSb3 Based Nanocomposites

Enhanced Thermoelectric Properties of P-Type CoSb3/graphene Nanocomposite

Enhanced Thermoelectric Properties of Nano-Sic Dispersed NaCo2O4 Composites

Thermoelectric Properties of Yb0.15Co4Sb12based Nanocomposites with CoSb3nano-inclusion

Enhanced thermoelectric properties of n-type CoSb3-based composites by incorporating In particles

High-Performance MoS 2 /SWCNT Composite Films for a Flexible Thermoelectric Power Generator

Pulsed Laser Deposition of BiCl3 Doped Bi2S3/Cu Nanoparticle Composite Films for Thermoelectric Applications

Facile and time-resolved chemical growth of nanoporous CaxCoO2 thin films for flexible and thermoelectric applications

High figure-of-merit of single-walled carbon nanotubes films with metallic type conduction

Thermoelectric properties and microstructure of nanocomposite Sb-GeO2 and Sb–TiO2 thin films

Nanostructured Bi2-Xcuxs3 Bulk Materials With Enhanced Thermoelectric Performance

CoSb3-based skutterudite nanocomposites prepared by cold sintering process with enhanced thermoelectric properties

Nanostructured Sb2Te3 films composited with Bi2S3 for p–n conduction type conversion

Formation Mechanism and High Thermoelectric Performance of Cu5+3xFe1‐xS4 Icosahedral Nanoparticles with Distinctive Core‐Shell Structures (Adv. Energy Mater. 47/2022)

Enhanced performance of thermoelectric nanocomposites based on Cu12Sb4S13 tetrahedrite

Thermoelectric Properties of CoSb&lt;sub&gt;3&lt;/sub&gt; Nanoparticle Films