Abstract:This paper attempts to present a brief review of recent progress obtained by the author's group in the research area of ion beam metallurgy, namely (i) formation of metal-nitride by nitrogen implantation; (ii) metallic glass formation by ion mixing; and (iii) icosahedral phase formation by ion mixing. Silver- and copper-trinitrides have been formed, for the first time, by RT 80 keV nitrogen ion implantation for doses up to 2×10 18 N cm −2 . These indicated that deposition of large amounts of energy during implantation could provide the reaction energy of noble-metal-nitride with rather positive heat of formation, and that local nitrogen concentration in the implanted films could be considerably greater than that limited by the sputtering yield involved. Besides, our observation of the reverse sequence of phase transition TiTiNTi 2 N with increasing nitrogen dose suggested that growth kinetics (or structural compatibility between newly formed phase and the matrix) might be a key factor in determining the nitride formation in some systems. Two parameters were found of importance in influencing the glass forming ability (GFA) of binary metal systems. One is MPAR (maximum possible amorphization range), which equals 100% minus the maximum solid solubilities observed in the equilibrium phase diagram. The other is the heat of formation. A map was constructed by these parameters and some empirical qualifications were found to classify the systems according to GFA into three categories of Hardly (HGF), Possible (PGF) and Readily (RGF) Glass Forming systems. The FeCu system is an immiscible one, in which amorphization induced by ion mixing could only occur within a narrow composition range. The favored composition was figured out experimentally, and an icosahedral phase was also formed by ion mixing without post-annealing at corresponding atomic stoichiometry. Interestingly, a similar phase was also formed in the FeMo system.

Formation and Structural Transformation of the Nonequilibrium Phases in the Ru–Ta System Induced by Ion Beam Mixing

Formation of Nonequilibrium Phases and Associated Structural Transitions in the Rh–Ta System Induced by Ion Beam Mixing

Structural phase transition in the Fe–Ta system studied by ion beam mixing

Formation of Non-Equilibrium Phases and Associated Structural Transition in the Pd-Ta System Induced by Ion Beam Mixing

Amorphous phase formation in the Ni–Ti–Ta system studied by thermodynamic calculation and ion beam mixing

Metastable phase formation in an immiscible Cu-Ta system studied by ion-beam mixing, ab initio calculation, and molecular dynamics simulation

Irradiation-induced Alloying in an Immiscible TaTi System

Stability of the metastable phases in the Co-Ta system studied by ab initio and thermodynamic calculations together with ion-beam-mixing experiment

Nonequilibrium hcp and fcc phases formed by ion mixing in an immiscible Ni–Ru system

Metastable alloys synthesized by ion mixing in immiscible Ti–Nb and Ti–Ta systems

Nonequilibrium Crystalline Phases Formed in the Co-Ta System by Ion-Beam Mixing

Glass Forming Ability In The Equilibrium Immiscible Ag-Ta System Studied By Molecular Dynamics Simulation And Ion Beam Mixing

Amorphous Alloy Formation in Immiscible Cu-Ta and Cu-W Systems by Atomistic Modeling and Ion-Beam Mixing

Ion Mixing to Synthesize Amorphous and Metastable Crystalline Alloys in the Fe-Ta System

Non-equilibrium Alloy Phase Formation and Transformation Driven by Ion Beam Mixing in the Fe-Hf-Nb Multilayers

Glass forming abilities of the Fe–Ta–(Zr, Ti) alloys studied by thermodynamic calculation and ion beam mixing

Study Of Alloy Phase Formation Using Ion-Beams

Formation of an Face-Centered Cubic Ta-Rich Solid Solution by Ion Beam Mixing in the Immiscible Ag-Ta System

Formation and Magnetic Properties of Metastable Phases Observed in the Fe50(HfxTa1−x)50 Films by Ion Beam Mixing

Metastable phase formation and transformation studied by ion mixing and computation for the Cu–Zr–Ni system

Magnetic Properties Of Some Metastable Co-Ru Alloys Studied By Ion Beam Mixing And Ab Initio Calculation