The vapor-liquid equilibrium of acetic acid-water system and its simulation of the distillation process

耿皎,吴有庭,刘庆林,张志炳

DOI: https://doi.org/10.3321/j.issn:0469-5097.2000.04.018

2000-01-01

Abstract:For calculating the vapor-liquid equilibrium of acetic acid-water system, deviations usually become the key factors affecting the accuracy of computed results. The non-ideal behavior in the vapor and liquid phase must be taken into account even at a low pressure. The earlier method to calculate vapor phase fugacity is by the "The Chemical Theory" and is proved to be more accurate, but very much complicated in programming the computing process. In this work, "The Chemical Equilibrium Theory" (CET) is introduced to replace "The Chemical Theory" to account for nonideality in the vapor phase. The content of this method is to regard association of acetic acid molecules as a process of equilibrium reaction, in which equilibrium constants K can be defined and determined by experiments. Because of the association in the vapor phase, new species will be formed such as dimers, trimers etc. They can be treated as individual components in vapor phase, while monomers in liquid phase only. The non-ideality in the liquid phase including association can be lumped into the two activity coefficients of acetic acid and water, which can be calculated by some thermodynamic models such as Wilson equations. Through the above-stated treatment, not only a result is achieved in good agreement with the experiment, but also indicates the computing process in quite a simple and rapid way. On the basis of above study the distillation process of acetic acid and water system is investigated by mathematical simulation and experiments. The mathematical model in the simulation is resolved by the conventional methed. For separating a known mixture in given specifications, reflux ratio, feeding position and other operating variables as well as their ralationships are predicted. The theoretical results for the distillation process are also compared with those from software such as Hysim, Design II, etc. and the experimental data from a distillation. The resutts show that the needed theoretical stages calculated by using the "CET" method for separating the mixture of acetic acid-water at a certain reflux ratio, in a given feeding composition and specifications, are about 30% more than those from Hysim and Design II. This is basically identical to the data from the distillation test.