Abstract:A microchannel heat sink (MCHS) is known as a heat dissipation device from the miniaturized electronic components and devices due to its capability to dissipate high heat flux from smaller surface area. However, the higher pressure drop and the uneven heat removal along the channel length are the noticeable disadvantages of MCHS. Though there are attempts to address these shortcomings, no existing study has been found to study the effect of positions of microstructures (micro-pin fin and blind holes) and combined effect of micro-pin fins and blind holes under flow boiling condition. Therefore, in the present study, an attempt has been made to logically explain the effect of various arrangements and positions of pin fins and blind holes in the selected twenty-four uniformly distributed stations on the thermohydraulic performance of MCHS through numerically predicted results. The objectives of the study have been attained using the following three analyses, flow boiling, (i) with saturated fluid inlet conditions (inlet Re = 500), (ii) with different inlet subcooling (20, 40, and 60 °C ), and (iii) with different heat flux conditions (100, 150, 200 and 250 W/cm2 ). From the study, it is observed that the pin fin enhances heat transfer in single-phase flow and delays the phase change by disturbing the flow. The blind holes act as nucleation sites and help phase change heat transfer. It is also observed that the ratio of single-phase and two-phase length and arrangement of microstructures in these two regions predominately dominate the heat transfer and fluid flow characteristics of the microchannel heat sink. The optimum performance (maximum heat transfer coefficient and minimum pressure drop) is achieved when twelve pin fins are placed in the upstream half and twelve blind holes are located at the downstream half of the channel. However, design improvement is possible through more computational and experimental analysis.

Experimental Investigation on Flow and Heat Transfer Characteristics of the Drop-Pressure Microchannel Heat Sink with Gradient Distribution Pin Fin Arrays and Narrow Slots

An Experimental Study of Microchannel and Micro-Pin-Fin Based On-Chip Cooling Systems with Silicon-to-Silicon Direct Bonding.

Thermohydraulic Performance Optimization of Integrated Porous Pin Fins in Microchannel Heat Sink Using Shape Optimization Coupled with NSGA

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Numerical investigation on thermal-hydraulic characteristics of the micro heat sink with gradient distribution pin fin arrays and narrow slots

Numerical study on hydrothermal performance in a microchannel with gradient array of ribs and pin fins

Study on the efficient heat transfer mechanism of microchannel pin-fin arrays under low pumping power

Development and numerical investigation of novel gradient-porous heat sinks

Assessment of cooling performance of mini/micro-channel stacked double layer heat sink

Fluid flow and heat transfer characteristics of a microstructured microchannel heat sink under flow boiling condition

Experimental study on thermal performance of water/nano-phase change emulsion through a mini- and micro-channel stacked double-layer heat sink

Numerical Study on Heat Transfer Efficiency and Inter-Layer Stress of Microchannel Heat Sinks with Different Geometries

Numerical Investigations of the Thermal-Hydraulic Characteristics of Microchannel Heat Sinks Inspired by Leaf Veins

Experimental Study of Single Phase Heat Transfer and Pressure Loss in a Spiraling Radial Inflow Microchannel Heat Sink

Experimental study of flow boiling in microchannel heat sink enhanced with partially in-line pin fins fence arrangement

Investigation of fluid flow and heat transfer characteristics in a microchannel heat sink with double-layered staggered cavities

Numerical Study on Hybrid Discontinuous Microchannel Heat Sink Combining Manifold with Pin Fins (DMC-MPF) for High Power Electronic Device

Numerical study of different micro-channel structures on fluid flow and heat transfer performance

Experimental study of embedded manifold staggered pin-fin microchannel heat sink

On the assessment of the thermal performance of microchannel heat sink with nanofluid

Microscale Heat Transfer Enhancement Using Thermal Boundary Layer Redeveloping Concept