Abstract:Previous studies have shown that the two-layer model more accurately predicts hydrogen dispersion than the conventional notional nozzle models without significantly increasing the computational expense. However, the model was only validated for predicting the concentration distribution and has not been adequately validated for predicting the ve-locity distributions. In the present study, particle imaging velocimetry (PIV) was used to measure the velocity field of an underexpanded hydrogen jet released at 10 bar from a 1.5 mm diameter orifice. The two-layer model was the used to calculate the inlet conditions for a two-dimensional axisymmetric CFD model to simulate the hydrogen jet downstream of the Mach disk. The predicted velocity spreading and centerline decay rates agreed well with the PIV measurements. The predicted concentration distribution was consistent with data from previous planar Rayleigh scattering measurements used to verify the concen-tration distribution predictions in an earlier study. The jet spreading was also simulated using several widely used notional nozzle models combined with the integral plume model for comparison. These results show that the velocity and concentration distributions are both better predicted by the two-layer model than the notional nozzle models to com-plement previous studies verifying only the predicted concentration profiles. Thus, this study shows that the two-layer model can accurately predict the jet velocity distributions as well as the concentration distributions as verified earlier. Though more validation studies are needed to improve confidence in the model and increase the range of validity, the present work indicates that the two-layer model is a promising tool for fast, accurate predictions of the flow fields of underexpanded hydrogen jets. (c) 2020 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved. Previous studies have shown that the two-layer model more accurately predicts hydrogen dispersion than the conventional notional nozzle models without significantly increasing the computational expense. However, the model was only validated for predicting the concentration distribution and has not been adequately validated for predicting the velocity distributions. In the present study, particle imaging velocimetry (PIV) was used to measure the velocity field of an underexpanded hydrogen jet released at 10 bar from a 1.5 mm diameter orifice. The two-layer model was the used to calculate the inlet conditions for a two-dimensional axisymmetric CFD model to simulate the hydrogen jet downstream of the Mach disk. The predicted velocity spreading and centerline decay rates agreed well with the PIV measurements. The predicted concentration distribution was consistent with data from previous planar Rayleigh scattering measurements used to verify the concentration distribution predictions in an earlier study. The jet spreading was also simulated using several widely used notional nozzle models combined with the integral plume model for comparison. These results show that the velocity and concentration distributions are both better predicted by the two-layer model than the notional nozzle models to complement previous studies verifying only the predicted concentration profiles. Thus, this study shows that the two-layer model can accurately predict the jet velocity distributions as well as the concentration distributions as verified earlier. Though more validation

Comparison of Two-Layer Model for High Pressure Hydrogen Jets with Notional Nozzle Model Predictions and Experimental Data

Comparison of Two-Layer Model for Hydrogen and Helium Jets with Notional Nozzle Model Predictions and Experimental Data for Pressures Up to 35 MPa

Validation of a Reduced-Order Jet Model for Subsonic and Underexpanded Hydrogen Jets

Comparison of numerical and algebraic models of low and high pressure hydrogen jet flows with ideal and real gas models

Validation of Two-Layer Model for Underexpanded Hydrogen Jets

Modeling of underexpanded hydrogen jets through square and rectangular slot nozzles

Simplified Partitioning Model to Simulate High Pressure Under-Expanded Jet Flows Impinging Vertical Obstacles

A Comparison Between Direct Numerical Simulation and Experiment of the Turbulent Burning Velocity-Related Statistics in a Turbulent Methane-Air Premixed Jet Flame at High Karlovitz Number

Modeling of Cryogenic Compressed Hydrogen Jet Flames

High‐pressure under‐expanded hydrogen leakage model considering gas‐wall friction loss

Modeling of Supercritical-Pressure Turbulent Combustion of Hydrocarbon Fuels Using A Modified Flamelet-Progress-Variable Approach

Direct Numerical Simulation of a Supersonic Lifted Hydrogen Jet Flame: A Priori Study on Combustion Models

Experimental investigation and model analysis of non-premixed hydrogen jet flames

High-Fidelity Resolution of the Characteristic Structures of A Supersonic Hydrogen Jet Flame with Heated Co-Flow Air

Laminar flame speed modeling of pre-vaporized jet fuel/hydrogen mixtures under engine conditions

An Experimental Study of the Characteristics of Blended Hydrogen-Methane Non-Premixed Jet Flames

Modeling of cryogenic hydrogen releases

Numerical Simulation of Hydrogen Release from High-Pressure Storage Vessel

Measurements of Concentration Decays in Underexpanded Jets Through Rectangular Slot Nozzles

Isentropic analysis and numerical investigation on high-pressure hydrogen jets with real gas effects

Analytical Investigation of Hydrogen Distribution with Steam Condensation in Confined Vessel