Abstract:This letter reviews some fundamental trade-offs in RF amplifier design as well as optimization from devices to circuit design using nano-scale CMOS process, that reduces the impact of manufacturing variations on integrated wideband low noise amplifiers (LNA). The design considerations include the unity-gain frequency, high frequency noise, power consumption and linearity of active devices in addition to accurate physic models for passive components such as RF and transmission lines. All these considerations are traded off among a system designs aspect. For an example in a commercial 65 nm CMOS technology design, by optimizing the unity width of the transistors and the transmission lines, a three-stage LNA achieves a peak gain of 22.3 dB at 60 GHz with a Noise Figure of 5.17 dB. Each stage consumes 5.2 mA from a supply voltage of 1.5 V. By using Monte Carlo simulation, the LNA with optimized transistor and interconnects has a higher gain and lower Noise Figure. The circuit is able to work robustly against process variations by optimizing the transistors and the transmission lines.

Design Methodology for Power-Constrained Low Noise RF Circuits

A novel design optimization method of fully integrated CMOS low noise amplifier

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

Analysis and Design of Wideband Low Noise Amplifier with Digital Control

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

Miller Effect Analysis and Noise Optimization of CMOS Low Noise Amplifier

5 GHz LNA based on CHRT 0.18 μm CMOS technology

Design and Optimization of a Milli-Meter Wave Amplifier Using Nano-Scale CMOS Devices

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A BiCMOS Implementation of Noise Canceling Low Noise Amplifier for Wideband Applications

Ultralow Power E-Band Low-Noise Amplifier with Three-Stacked Current-Sharing Amplification Stages in 28-Nm CMOS

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

A Highly Linear 2.4GHz Low Noise Amplifier

Design of a Low Power CMOS Low Noise Amplifier

The Design Of Cmos Rf Low Noise Amplifiers

Design And Simulation Of Low Noise Amplifier For Radio Frequency Front End Of Wireless Communication

Millimeter-Wave Low-Noise Amplifier Design in 28-nm Low-Power Digital CMOS

Technologies, Design, and Applications of Low-Noise Amplifiers at Millimetre-Wave: State-of-the-Art and Perspectives

A 20-GHz 4.8-dB NF low noise amplifier

Design of a Low Noise Amplifier

An Optimization Design Methodology for CMOS UWB LNA