Electrocatalytic Oxidation of Gaseous Toluene in an All-Solid Cell Using a Foam Ti/Sb-SnO 2 /Β-Pbo 2 Anode

Zhikun Liu,Weiming Qian,Min Chen,Wenshuo Zhou,Boying Song,Bo Zhang,Xiaolei Bao,Qiong Tang,Yongchun Liu,Changbin Zhang
DOI: https://doi.org/10.1016/j.jes.2022.10.039
IF: 6.9
2023-01-01
Journal of Environmental Sciences
Abstract:Mineralization of benzene,toluene,and xylene (BTX) with high efficiency at room temperature is still a challenge for the purification of indoor air.In this work,a foam Ti/Sb-Sn O 2 /β-Pb O 2 anode catalyst was prepared for electrocatalytically oxidizing gaseous toluene in an all-solid cell at ambient temperature.The complex Ti/Sb-Sn O 2 /β-Pb O 2 anode,which was prepared by sequentially deposing Sb-Sn O 2 and β-Pb O 2 on a foam Ti substrate,shows high electrocatalytic oxidation efficiency of toluene (80%) at 7 hr of reaction and high CO 2 selectivity (94.9%) under an optimized condition,i.e.,a cell voltage of 2.0 V,relative humidity of60%and a flow rate of 100 m L/min.The better catalytic performance can be ascribed to the high production rate of·OH radicals from discharging adsorbed water and the inhibition of oxygen evolution on the surface of foam Ti/Sb-Sn O 2 /β-Pb O 2 anode when compared with the foam Ti/Sb-Sn O 2 anode.Our results demonstrate that prepared complex electrodes can be potentially used for electrocatalytic removal of gaseous toluene at room temperature with a good performance.
What problem does this paper attempt to address?